is defined as remodeling, renovating, rehabilitating, reconstructing, changing or rearranging structural parts or elements, changing or rearranging plan configuration of walls and full-height...
Search Results "Character Height (Raised)"
-
Alterations
-
The Purpose of FSORAG and FSTAG
included (scoping); what has to comply with the guidelines; definitions of terms; and technical requirements defining the physical characteristics of accessible features, such as width, height...
-
4.16.6 Dispensers
As a result, the dispenser was located 24" above the floor, 5" higher than the minimum height in ADAAG, and 42" from the rear wall (Figure 13), which would have been too high and too far...
-
Additional Features of Van-Accessible Parking Spaces
Vertical clearance of 98 inches minimum to accommodate van height at the vehicle parking space, the adjacent access aisle, and on the vehicular route to and from the van-accessible space...
-
11B-703.3.1 Dimensions and capitalization
1.6 mm) Distance between two dots in the same cell1 0.100 (2.5 mm) Distance between corresponding dots in adjacent cells1 0.300 (7.6 mm) Dot height...
-
11B-404.2.10 Door and gate surfaces
stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch (254 mm) bottom smooth surface height...
-
11B-703.3.1 Dimensions and capitalization
dots in the same cell1 0.100 (2.5 mm) Distance between corresponding dots in adjacent cells1 0.300 (7.6 mm) Dot height...
-
11B-404.2.10 Door and gate surfaces
stiles and having a bottom rail or shoe with the top leading edge tapered at 60 degrees minimum from the horizontal shall not be required to meet the 10 inch (254 mm) bottom smooth surface height...
-
M303.2.4 Equipment Clearances (Section-by-Section Analysis)
Due to the reorganization of the equipment clearances provision in the final rule, the knee and toe clearance requirements for the other equipment section have been renamed depth and height...
-
H. Your Obligation to Provide Services and Equipment
[Sec. 382.21(a)(4)] On-board wheelchairs must be equipped with footrests, armrests which are movable or removable, adequate occupant restraint systems, a backrest height that permits assistance...
-
III 3.11000 Insurance
ILLUSTRATION: An amusement park requires individuals to meet a minimum height requirement that excludes some individuals with disabilities for certain rides because of a limitation in its...
-
Section 36.302 Modifications in Policies, Practices, or Procedures (Preamble, Section-by-Section Analysis)
For example, a parking facility would be required to modify a rule barring all vans or all vans with raised roofs, if an individual who uses a wheelchair-accessible van wishes to park in...
-
Section 36.302 Modifications in Policies, Practices, or Procedures (Section-By-Section Analysis and Response to Comments)
For example, a parking facility would be required to modify a rule barring all vans or all vans with raised roofs, if an individual who uses a wheelchair-accessible van wishes to park in...
-
Meeting ANSI Standard S12.60 Requirements
For classrooms where there is no fixed lecture position for the teacher, such as those for lower grades, and where ceiling heights are less than ten feet, the best option is to place most...
-
1.3.1 Overview of NPRM
Equipment to Which Technical Criteria Applies Diagnostic Equipment Used by Patients in Supine, Prone, or Side-Lying Position (M301) Transfer surface, including height...
-
Road Roughness Measurements
(Figure 8) An inertial profiler uses an accelerometer and a non-contacting sensor, such as a laser transducer, to measure height....
-
Measuring Techniques
However, if a very large chair were purchased often, then it would have the effect of raising the 95th percentile, and in turn, changing the design target....
-
CRL Jackson 900 Series Floor Mounted Door Closers
Capacity, 42" Doors The Perfect Door Closer to Support CRL's Patch Hardware Narrow 3-1/16" (78 mm) Width Interchangeable Spindle Heights 5 Year Limited Warranty...
-
Sizewise SW Low Boy
The SW Low Boy® is changing the way hospitals and long term care facilities address fall prevention by offering the industry’s first bariatric low bed with a low resting height of 7” and...
-
GameTime ADA Wide Ramp Attachment 3D
Specifications Model Number - 91044 Fall Height - Deck Height Age Groups - 2 to 5 or 5 to 12 years...
-
American Standard Madera 1.28 gpf ADA Toilet with Exposed Manual Flush Valve System
and back spud, less seat High Effeciency, low consumption 1.28 GPF Conventional glazed Fully glazed 2-1/8” trapway 10" or 12" rough-in 16-1/2” rim height...
-
American Standard Madera 1.6 gpf ADA Toilet with Exposed Manual Flush Valve System
and back spud, less seat High Effeciency, low consumption 1.6 GPF Conventional glazed Fully glazed 2-1/8” trapway 10" or 12" rough-in 16-1/2” rim height...
-
SafePath BigHorn™ Ramps
surface in threshold design, much safer than aluminum Peel-and-stick tape for immediate installation Perfect for wheelchairs, scooters and electric chairs Can be vertically cut for height...
-
Atlantis Railing
SPECIFICATIONS: Ramp Sections: The SunRailTM AccessEasy System is offered in a standard height of 42" with a handrail height of 36"....
