(i) Where existing elements prohibit strict compliance with the clearance requirements of 4.13.5, a projection of 5/8 in (16 mm) maximum will be permitted for the latch side door stop....
Search Results "Building Permit"
-
4.1.6(4)(d)
-
§1630.14(d)(4)(iv)
(iv) A covered entity shall not require an employee to agree to the sale, exchange, sharing, transfer, or other disclosure of medical information (except to the extent permitted by this...
-
§ 38.113(a)(2)
maximum extent practicable in accordance with regulations issued under the Federal Railroad Safety Act of 1970 (49 CFR parts 229 and 231), shall have a clear opening width of 32 inches to permit...
-
11B-409.3.1 Power operation
Exception: In elevator cars with more than one opening, hoistway doors and gates shall be permitted to be of the manual-open, self-close type....
-
§ 38.159(a)(1) General
., lift or ramp) complying with paragraph (b) or (c) of this section and sufficient clearances to permit a wheelchair or other mobility aid user to reach a securement location....
-
11B-409.3.1 Power operation
Exception: In elevator cars with more than one opening, hoistway doors and gates shall be permitted to be of the manual-open, self-close type....
-
Other Power-driven Mobility Devices (OPDMDs)
at different times of the day, week, month, or year); the facility's design and operational characteristics; whether legitimate safety requirements can be established to permit...
-
1022.9 Stairway identification signs
Sections 11B-703.1, 11B-703.2, 11B-703.3 and 11B-703.5 shall be located at the landing of each floor level, placed adjacent to the door on the latch side, in all enclosed stairways in buildings...
-
Automatic Doors
In the proposed rule, section 404.3 noted that "[a]utomatic doors shall be permitted on an accessible route."...
-
Alterations and water closet clearances in single-user toilet rooms with in-swinging doors. (Section-by-Section Analysis)
Section 603.2.3 of the 2010 Standards maintains the prohibition on doors swinging into the clear floor space or clearance required for any fixture, except that they permit the doors of toilet...
-
Executive Summary
On 29-30 September 2010, the National Institute of Building Sciences and the U.S....
-
§ 36.405(a)
(a) Alterations to buildings or facilities that are eligible for listing in the National Register of Historic Places under the National Historic Preservation Act (16 U.S.C. 470 et seq) or...
-
MULTI-BEDROOM HOUSING UNIT
Multi-bedroom housing units are separate from one another and from common use spaces within a building....
-
MULTI-BEDROOM HOUSING UNIT
Multi-bedroom housing units are separate from one another and from common use spaces within a building....
-
NFPA
Revise Section 12.3.8.1 as follows: 12.3.8.1 The outgoing and return (redundant) circuit conductors shall be permitted in the same cable assembly (i.e., multiconductor cable), enclosure...
-
NFPA
Revise Section 12.3.8.1 as follows: 12.3.8.1 The outgoing and return (redundant) circuit conductors shall be permitted in the same cable assembly (i.e., multiconductor cable), enclosure...
-
5. Advance Notice
Advance Notice We sought comments in the Oxygen NPRM about operational reasons, if any, in support of permitting carriers to require a passenger with a disability to provide advance notice...
-
Safe Harbors
A primary entrance to the building or facility, 2. Toilet and bathing facilities serving the area, 3. Drinking fountains serving the area, 4. ...
-
11B-407.4.8.2.1 Signal type
per minute (1 m/s) or less, a non-verbal audible signal with a frequency of 1500 Hz maximum which sounds as the car passes or is about to stop at a floor served by the elevator shall be permitted...
-
§382.129(a)
(a) As a carrier, you must permit passengers with a disability to provide written directions concerning the disassembly and reassembly of their wheelchairs, other mobility aids, and other...
-
11B-306.3.4 Clearance reduction
Between 9 inches (229 mm) and 27 inches (686 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches...
-
11B-407.2.1.1 Height
[2010 ADAS] EXCEPTION: Existing call buttons and existing keypads shall be permitted to be located at 54 inches (1370 mm) maximum above the finish floor, measured to the centerline...
-
M305.2.1 Location
EXCEPTION: Where the support folds, collapses, or articulates, the transfer support shall be permitted to be located 3 inches (75 mm) maximum from the plane defined by the nearest edge of...
-
11B-612.2 Bench
Exception: A readily removable bench shall be permitted to obstruct the turning space required by Section 11B-612.3 and the clear floor or ground space required by Section 11B-903.2....