Contents of guidelines The supplemental guidelines issued under subsection (a) of this section shall establish additional requirements, consistent with this chapter, to ensure that buildings...
Search Results "Building Permit"
-
12204(b) Contents of guidelines
-
Scoping [4.1.3(7)]
Scoping [4.1.3(7)] Doors required to be accessible include: at least one door at each accessible entrance at least one door at each accessible space within a building...
-
4.1.4 OCCUPANCY CLASSIFICATIONS
Buildings and facilities shall comply with these standards to the extent noted in this section for various occupancy classifications, unless otherwise modified by a special application section...
-
4.1.7(1)(b)
required by part 4 for accessible routes (exterior and interior), ramps, entrances, toilets, parking, and displays and signage, would threaten or destroy the historic significance of the building...
-
4.28.4* AUXILIARY ALARMS
Accessible sleeping accommodations shall have a visual alarm connected to the building emergency alarm system or shall have a standard 110-volt electrical receptacle into which such an alarm...
-
7.3 CHECK-OUT AISLES
At least one accessible check-out aisle shall be provided in buildings or facilities with check-out aisles....
-
Other Power-driven Mobility Devices (OPDMDs)
at different times of the day, week, month, or year); the facility's design and operational characteristics; whether legitimate safety requirements can be established to permit...
-
Automatic Doors
In the proposed rule, section 404.3 noted that "[a]utomatic doors shall be permitted on an accessible route."...
-
Alterations and water closet clearances in single-user toilet rooms with in-swinging doors. (Section-by-Section Analysis)
Section 603.2.3 of the 2010 Standards maintains the prohibition on doors swinging into the clear floor space or clearance required for any fixture, except that they permit the doors of toilet...
-
1022.9 Stairway identification signs
Sections 11B-703.1, 11B-703.2, 11B-703.3 and 11B-703.5 shall be located at the landing of each floor level, placed adjacent to the door on the latch side, in all enclosed stairways in buildings...
-
Executive Summary
On 29-30 September 2010, the National Institute of Building Sciences and the U.S....
-
NFPA
Revise Section 12.3.8.1 as follows: 12.3.8.1 The outgoing and return (redundant) circuit conductors shall be permitted in the same cable assembly (i.e., multiconductor cable), enclosure...
-
NFPA
Revise Section 12.3.8.1 as follows: 12.3.8.1 The outgoing and return (redundant) circuit conductors shall be permitted in the same cable assembly (i.e., multiconductor cable), enclosure...
-
§ 36.405(a)
(a) Alterations to buildings or facilities that are eligible for listing in the National Register of Historic Places under the National Historic Preservation Act (16 U.S.C. 470 et seq) or...
-
MULTI-BEDROOM HOUSING UNIT
Multi-bedroom housing units are separate from one another and from common use spaces within a building....
-
MULTI-BEDROOM HOUSING UNIT
Multi-bedroom housing units are separate from one another and from common use spaces within a building....
-
5. Advance Notice
Advance Notice We sought comments in the Oxygen NPRM about operational reasons, if any, in support of permitting carriers to require a passenger with a disability to provide advance notice...
-
11B-407.4.8.2.1 Signal type
per minute (1 m/s) or less, a non-verbal audible signal with a frequency of 1500 Hz maximum which sounds as the car passes or is about to stop at a floor served by the elevator shall be permitted...
-
§382.129(a)
(a) As a carrier, you must permit passengers with a disability to provide written directions concerning the disassembly and reassembly of their wheelchairs, other mobility aids, and other...
-
11B-306.3.4 Clearance reduction
Between 9 inches (229 mm) and 27 inches (686 mm) above the finish floor or ground, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for each 6 inches...
-
11B-407.2.1.1 Height
[2010 ADAS] EXCEPTION: Existing call buttons and existing keypads shall be permitted to be located at 54 inches (1370 mm) maximum above the finish floor, measured to the centerline...
-
M305.2.1 Location
EXCEPTION: Where the support folds, collapses, or articulates, the transfer support shall be permitted to be located 3 inches (75 mm) maximum from the plane defined by the nearest edge of...
-
11B-612.2 Bench
Exception: A readily removable bench shall be permitted to obstruct the turning space required by Section 11B-612.3 and the clear floor or ground space required by Section 11B-903.2....
-
M301.4 Lift Compatibility
EXCEPTION: Where fixed overhead patient lifts are provided, and when their use with diagnostic equipment is permitted by an enforcing authority, diagnostic equipment shall not be required...