Passenger drop-off and loading zones shall provide access aisles complying with Section 11B-503 adjacent and parallel to the vehicle pull-up space....
Search Results "Clear Floor Space"
Filters
Commonly Searched Documents
-
11B-503.3 Access aisle
-
M303.2.4 Equipment Clearances (Section-by-Section Analysis)
The MDE NPRM proposed knee and toe clearance for diagnostic equipment used by patients seated in wheelchairs to allow for components in the wheelchair space which the patient could approach...
-
Employee Work Areas—Section 203.9 of the 2010 Standards, and Similar Sections
The 2010 Standards require a more limited level of access within employee work areas in ADA-covered facilities than UFAS, which requires employee work areas to be fully accessible....
-
Technical difficulty and readily achievable
Along with cost and business operation, the technical feasibility of barrier removal must be taken into consideration. It may be impossible to alter or expand a bathroom due to load...
-
§ 37.43(e)(2)(i)
(i) Costs associated with providing an accessible entrance and an accessible route to the altered area (e.g., widening doorways and installing ramps);
-
11B-206.5.3 Transient lodging facilities
In transient lodging facilities, entrances, doors, and doorways providing user passage into and within guest rooms that are not required to provide mobility features complying with...
-
1009.3 Stairways
In order to be considered part of an accessible means of egress, a stairway between stories shall comply with Sections 1009.3.1 through 1009.3.3. [DSA·AC & HCD 1.AC] In addition,...
-
§ 36.302(f)(4)(iv) Maximum number of tickets patrons may purchase exceeds four
allowed to purchase more than four tickets, a public accommodation shall allow patrons with disabilities to purchase up to the same number of tickets, including the ticket for the wheelchair space...
-
11B-705.1.2.2.2.2 Two entrance/exit points
Where the turning space has two entrance/exit points other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep at both entrance/ exit points, as measured...
-
M303.3.1 Vertical (Section-by-Section Analysis)
The MDE NPRM proposed that for equipment with a change in level at the entry to the wheelchair space, level changes of up to ¼ inch high are permitted to be vertical....
-
Sec. 469.102. Procedure for Submitting Plans and Specifications
[See subsections ...]
-
11B-233.3.1.2.6.2 Test number one, individual building test
It is not required by this code to provide an accessible route when the terrain of the site is such that both of the following apply: 1. The slopes of the undisturbed site...
-
406.4.1 Clear height
[DSA-AC] The clear height of vehicle and pedestrian areas required to be accessible shall comply with Chapter 11A or 11B, as applicable. Advisory 406.4.1 Clear height....
-
M303.3.2 Beveled (Section-by-Section Analysis)
The MDE NPRM proposed that for equipment with a change in level at the entry to the wheelchair space, level changes greater than ¼ inch but not greater than ½ inch would be required to be...
-
How to Use The Change in Level Tool
A short tutorial on how to use ETA's Change in Level Tool for compliance surveys in the field. To purchase this tool, visit The Corada Shop. (Please note that the free...
-
407.12.3.2.2 Knee and Toe Space
Knee and toe space under ICT shall be 27 inches (685 mm) high minimum, 25 inches (635 mm) deep maximum, and 30 inches (760 mm) wide minimum and shall be clear of obstructions....
-
4.33.3* Placement of Wheelchair Locations
When the seating capacity exceeds 300, wheelchair spaces shall be provided in more than one location....
-
1016.5 Obstacles
This section contains technical requirements for obstacles on outdoor recreation access routes, passing spaces, and resting intervals....
-
4.8.2* Slope and Rise
Curb ramps and ramps to be constructed on existing sites or in existing buildings or facilities may have slopes and rises as allowed in 4.1.6(3)(a) if space limitations prohibit the use...
-
4.8.2* SLOPE AND RISE
Curb ramps and ramps to be constructed on existing sites or in existing buildings or facilities may have slopes and rises as shown in Table 2 if space limitations prohibit the use of a 1...
-
§ 38.55(b)
a width-to-height ratio between 3:5 and 1:1 and a stroke width-to-height ratio between 1:5 and 1:10, with a minimum character height (using an upper case “X”) of 5/8 inch, with “wide” spacing...
-
A. Background
physical disabilities lines of sight that are comparable to those for members of the general public, in that most or all of the wheelchair locations do not provide a line of sight to the floor...
-
T702 Signs
[See subsections ...]
