Submerged Depth Lifts must be designed so that the seat will submerge to a minimum of 18 inches below the stationary water level....
Search Results "Seat Width"
-
Submerged Depth
-
T214.1 General
Where provided for passenger use, operable parts at wheelchair spaces and priority seats, stop request systems, and fare collection devices serving passenger access routes shall comply with...
-
10. Shower Wand
Is there an adjustable height shower wand with at least a 60" long hose provided for persons who must shower from a seated position?...
-
2d
Is there an adjustable height shower wand with at least a 60" long hose provided for persons who must shower from a seated position?...
-
1j
Is there an adjustable height shower wand with at least a 60" long hose provided for persons who must shower from a seated position?...
-
8. Shower Curbs
Are the roll-in showers free of curbs or lips at the shower floor that would impede wheelchair approach and transfer onto the folding shower seat?...
-
11B-607.4.2.3 Head end wall
FIGURE 11B-607.4.2 GRAB BARS FOR BATHTUBS WITH REMOVABLE IN-TUB SEATS...
-
903.6 Structural Strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
§ 37.91(a)(2)
(2) To fold and store wheelchairs (to accommodate individuals who wish to transfer to coach seats) equal to not less than one half the number of single level rail passenger coaches in the...
-
903.6 Structural Strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
-
1002.6.2 Transfer Height
The height of transfer device seats shall be 14 inches (355 mm) minimum and 24 inches (610 mm) maximum measured from the load and unload surface....
-
Accessible Pool Stairs
ADAAG provisions for stairs include the requirement that all steps have uniform riser heights and uniform tread widths of not less than 11 inches, measured from riser to riser....
-
1007.6.1 Size
Such wheelchair spaces shall not reduce the required means of egress width....
-
What Are the Requirements for Accessible Routes?
This section describes the various features of accessible routes within a play area, including location, clear width, slope, and accessible surfaces. ...
-
1003.2.13.5.1 Size
Such wheelchair spaces shall not reduce the required means of egress width....
-
1016.6 Openings
Where possible, drainage grates should be located outside the minimum clear width of the recreation access route....
-
810.2.2 Dimensions--Modification to 810.2.2 of Appendix D to 36 CFR Part 1191
Appendix D to 36 CFR Part 1191 Bus boarding and alighting areas shall provide a clear length of 96 inches (2440 mm), measured perpendicular to the curb or vehicle roadway edge, and a clear width...
-
11B-607.4.1.2 Control end wall
FIGURE 11B-607.4.1 GRAB BARS FOR BATHTUBS WITH PERMANENT SEATS...
-
11B-1009.2.8 Submerged depth
The lift shall be designed so that the seat will submerge to a water depth of 18 inches (457 mm) minimum below the stationary water level....
-
§382.141(a)
(a) As a carrier that operates aircraft with 19 or more passenger seats, you must provide training, meeting the requirements of this paragraph, for all personnel who deal with the traveling...
-
5.8.2.7.1 Mammography Chair Footrest
Mammography chairs must meet the requirements for equipment used for patient in a seated position with the additional requirement that any footrests must accommodate and ride over the base...
-
2b
Are all large showers free of curbs or lips at the shower floor that would impede wheelchair approach and transfer onto the folding shower seat?...
-
12186(a)(2)(C) Limitation on requiring installation of accessible restrooms
restrooms The regulations issued pursuant to this paragraph shall not require the installation of accessible restrooms in over-the-road buses if such installation would result in a loss of seating...
-
405.1 General
EXCEPTION: In assembly areas, aisle ramps adjacent to seating and not serving elements required to be on an accessible route shall not be required to comply with 405....