Architectural and Transportation Barriers Compliance Board (Access Board)....
Search Results "Level Boarding"
-
§ 38.171(c)
-
Tactile Surface
The Board has removed the provisions concerning equivalent products and technologies as an alternative to the detectable warnings specified by section 705....
-
R308.1.2.2 Slope
Boarding platforms shall not exceed a slope of 2 percent in any direction....
-
Maximum Slope at Ground Level
Maximum Slope at Ground Level The maximum allowable slope for a ground-level accessible route is 1:16. Berms are sometimes used to provide access to elevated play areas....
-
§ 38.83(a)(1) General
All new light rail vehicles, other than level entry vehicles, covered by this subpart shall provide a level-change mechanism or boarding device (e.g., lift, ramp or bridge plate) complying...
-
810.5.3 Platform and Vehicle Floor Coordination--Modification to 810.5.3 of Appendix D to 36 CFR Part 1191
Low-level platforms shall be 8 inches (205 mm) minimum above top of rail....
-
Figure 303.2 Vertical Change in Level – Drawing from the U.S. Access Board
-
Figure 303.3 Beveled Change in Level – Drawing from the U.S. Access Board
-
Tread Surface: ADA Standard Section 504.4
Section 504.4 covers the current ADA Standards for the tread surfaces on stairways.
-
IV.B.1.
Where destination or route information is displayed on the exterior of a vehicle, each vehicle shall have illuminated signs on the front and boarding side of the vehicle....
-
Track Crossing
The proposed rule required route surfaces to be level with the rail top, but permitted a 2 ½ inch gap at the inner edge of rails to accommodate wheel flanges (1003.2.7)....
-
Connection: ADA Standard Section 810.2.3
Bus stop boarding and alighting areas shall be connected to streets, sidewalks, or pedestrian paths by an accessible route complying with 402....
-
10.3.1(10)
(10) Stations shall not be designed or constructed so as to require persons with disabilities to board or alight from a vehicle at a location other than one used by the general public....
-
11B-809.7.2 Changes in level
Changes in level shall comply with Sections 11B-303.2 and 11B-303.3....
-
12186(c) Consistency with ATBCB guidelines
issued under subsections (a) and (b) of this section shall be consistent with the minimum guidelines and requirements issued by the Architectural and Transportation Barriers Compliance Board...
-
§ 38.23(c)(6) Attachment
When in use for boarding or alighting, the ramp shall be firmly attached to the vehicle so that it is not subject to displacement when loading or unloading a heavy power mobility aid and...
-
11B-1008.2.5.1 Ground level
Ramp runs connecting ground level play components shall have a running slope not steeper than 1:16....
-
11B-1008.2.5.1 Ground level
Ramp runs connecting ground level play components shall have a running slope not steeper than 1:16....
-
11B-1008.2.5.1 Ground level
Ramp runs connecting ground level play components shall have a running slope not steeper than 1:16....
-
How to Use The Change in Level Tool
A short tutorial on how to use ETA's Change in Level Tool for compliance surveys in the field. To purchase this tool, visit The Corada Shop. ...
-
§ 38.83(c)(6)(i) Requirement
When in use for boarding or alighting, the ramp or bridge plate shall be attached to the vehicle, or otherwise prevented from moving such that it is not subject to displacement when loading...
-
A4.8.4 Landings
Level landings are essential toward maintaining an aggregate slope that complies with these guidelines....
-
1003.3.2 Boarding Pier Clearances
1003.3.2 Boarding Pier Clearances....
-
1003.3.2 Boarding Pier Clearances
Boarding piers at boat launch ramps shall provide clear pier space 60 inches (1525 mm) wide minimum and shall extend the full length of the boarding pier....
