Curb ramps, blended transitions and islands on accessible routes shall comply with Section 11B-406....
Search Results "Curb Ramp Surface"
Filters
Commonly Searched Documents
-
11B-406.1 General
-
11B-406.1 General
Curb ramps, blended transitions and islands on accessible routes shall comply with Section 11B-406....
-
Q4: Road Alteration Projects that Trigger Curb Ramp Improvements Not on State/Local Property
Q4: When a road alteration project triggers the requirement to install curb ramps, what steps should public (State or local) entities take if they do not own the sidewalk right-of-way needed...
-
11B-406.1 General
Curb ramps, blended transitions and islands on accessible routes shall comply with Section 11B-406....
-
DSA Drawing 11B-406-5C Curb Ramp Adjoining a Parking Access Aisle next to a Curb and Gutter (2016 CBC)
Requires the Premium User plan or above. (Login or upgrade your account!) -
4 [§ 4.7.2]
4 [§ 4.7.2] The gutter is the part of the street that borders the curb....
-
Clear Width: ADA Standard Section 405.5
Section 405.5 covers the current ADA Standards for the clear width requirements of ramps.
-
DSA Drawing 11B-406-8C Curb Ramp Adjoining a Parking Access Aisle with No Gutter (2016 CBC)
Requires the Premium User plan or above. (Login or upgrade your account!) -
Surface Hazards: ADA Standard Section 609.5
Section 609.5 covers the current ADA Standards for the surfaces of grab bars and adjacent surfaces.
-
Parking Lots
Ensure that curb cuts for ramps are located appropriately—beside, not IN the parking space....
-
405.10 Wet Conditions
Landings subject to wet conditions shall be designed to prevent the accumulation of water.
-
405.10 Wet Conditions
Landings subject to wet conditions shall be designed to prevent the accumulation of water.
-
405.10 Wet Conditions
405.10 Wet Conditions. Landings subject to wet conditions shall be designed to prevent the accumulation of water.
-
405.10 Wet Conditions
Landings subject to wet conditions shall be designed to prevent the accumulation of water.
-
11B-705.1.2.2.2.2 Two entrance/exit points
Where the turning space has two entrance/exit points other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep at both entrance/ exit points, as measured...
-
6 [§ 4.7.7]
If the curb ramp you are surveying has detectable warnings but they do not cover the entire ramp run, explain how they are different in the “Comments” section at the bottom of the form....
-
4.7.2 SLOPE
Slopes of curb ramps shall comply with 4.8.2. The slope shall be measured as shown in Fig. 11....
-
405.9.1 Extended Floor or Ground Surface
The floor or ground surface of the ramp run or landing shall extend 12 inches (305 mm) minimum beyond the inside face of a handrail complying with 505....
-
4.7.2 Slope
Slopes of curb ramps shall comply with 4.8.2. The slope shall be measured as shown in Fig. 11....
-
Stabila, Inc. Tech Digital Electronic Level Type 196-2
FEATURES: Precise slope measurements as needed for ADA 4.8.2 ramp compliance Fast and accurate readings Dual screens (Front & Top) allow easy viewing from any angle Electronic...
-
Detectable Warnings on Curb Ramps
[See subsections ...]
-
K. SIDEWALKS
Within three (3) years of the entry of this Consent Decree, the County will provide curb ramps or other sloped areas complying with the applicable architectural standards as permitted by...
-
K. SIDEWALKS
Within three (3) years of the entry of this Consent Decree, the County will provide curb ramps or other sloped areas complying with the applicable architectural standards as permitted by...
-
4.8.6 Cross Slope and Surfaces
The cross slope of ramp surfaces shall be no greater than 1:50. Ramp surfaces shall comply with 4.5....
