[DSA-AC] In addition to the requirements of this section, means of egress, which provide access to, or egress from, buildings or facilities where accessibility is required for...
Search Results "Circular Ramp"
Filters
Commonly Searched Documents
-
SECTION 1012 RAMPS
-
SECTION 1012 RAMPS
[DSA-AC] In addition to the requirements of this section, means of egress, which provide access to, or egress from, buildings or facilities where accessibility is required for...
-
Boost Your Business - Chapter 5 - Curb Ramps
Boost Your Business - Chapter 5 - Curb Ramps...
-
B6. Curb Ramp Slope
If a curb ramp is provided, is the slope of the ramp surface (not counting the side flares) no more than 1:12? [ADA Stds 4.7.2] Yes _____ No _____...
-
Q6: Curb Ramp Installation Work on Separate Contract
Q6: Is the curb ramp installation work required to be a part of the Plans, Specifications and Estimate package for an alteration project or can the curb ramp work be accomplished under a...
-
R305.2.2 Parallel Curb Ramps
R305.2.2 Parallel Curb Ramps. On parallel curb ramps, detectable warning surfaces shall be placed on the turning space at the flush transition between the street and sidewalk....
-
SECTION 1022 INTERIOR EXIT STAIRWAYS AND RAMPS
SECTION 1022 INTERIOR EXIT STAIRWAYS AND RAMPS...
-
11B-406.5.10 Diagonal curb ramps
Diagonal or corner type curb ramps are perpendicular or parallel curb ramps that are oriented diagonally at an intersection....
-
Landings
Landings Landings are the level surfaces at the top and bottom of each ramp run....
-
d-v
If a ramp is longer than 30 feet, is a level landing at least 60 inches long provided every 30 feet? [ADA Standards § 4.8.4] Yes No...
-
Problem One (Ramps)
Problem One: There is a six inch high step on the accessible route that has a ramp that is only three feet long, making the ramp too steep and, therefore, inaccessible....
-
Sides of Curb Ramps
Commenters advised that landings should be specified at the top of curb ramps. Response....
-
R207 Curb Ramps and Blended Transitions (Section-by-Section Analysis)
R207 Curb Ramps and Blended Transitions (Section-by-Section Analysis) Curb ramps, blended transitions, or a combination of curb ramps and blended transitions must connect the pedestrian...
-
When Ramps Are Required
When Ramps Are Required Ramps are required on composite structures with 20 or more elevated play components and must connect to at least 25 percent of the elevated play components. ...
-
Can handrail extensions wrap or turn?
Extensions are not required for continuous handrails along switchback or dogleg ramps or at aisle ramps serving seating in assembly areas....
-
R305.2.1 Perpendicular Curb Ramps
R305.2.1 Perpendicular Curb Ramps. On perpendicular curb ramps, detectable warning surfaces shall be placed as follows: 1....
-
Figure 406.4 Landings at the Top of Curb Ramps – Drawing from the U.S. Access Board
-
R407.1 General
Ramps shall comply with R407....
-
§ 38.23(c) Vehicle ramp
(c) Vehicle ramp—...
-
Curb Ramps and Blended Transitions (R309.4) (Section-by-Section Analysis)
Curb Ramps and Blended Transitions (R309.4) (Section-by-Section Analysis) Curb ramps or blended transitions must connect the access aisle serving each accessible on-street parking space...
-
4.8.7 Edge Protection
Ramps and landings with drop-offs shall have curbs, walls, railings, or projecting surfaces that prevent people from slipping off the ramp....
-
4.8.7 EDGE PROTECTION
Ramps and landings with drop-offs shall have curbs, walls, railings, or projecting surfaces that prevent people from slipping off the ramp....
-
11B-705.1.2.2.2.2 Two entrance/exit points
Where the turning space has two entrance/exit points other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep at both entrance/ exit points, as measured...
