Grab bars: Section 609 of the ADA-ABA standards [7] includes provisions for grab bars in areas where transfers are expected....
Search Results "ADA Compliance"
-
Grab bars
-
201.1 Scope
., and the ADA Standards for Accessible Design....
-
"Readily achievable.'' (Preamble, Section-by-Section Analysis)
The definition of "readily achievable'' follows the statutory definition of that term in section 301(9) of the ADA....
-
11B-226.1 General
In facilities covered by the ADA, this requirement does not apply to work surfaces used only by employees....
-
Directional visual sign vs. room identification tactile sign
If that is how this sign is used, it would be classified as a "visual" sign, and would require conformance with the ADA Standards section 703.5, and would not require the raised lettering...
-
Flush Controls On Toilets
With the flush control being on the top of the tank, is this a violation of the ADA requirements to be on the wide side?...
-
5.4 Recruitment
5.4 Recruitment The ADA is a nondiscrimination law. It does not require employers to undertake special activities to recruit people with disabilities....
-
11B-215.5 Residential facilities
[2010 ADAS] 215.5 Residential Facilities. Where provided in residential dwelling units required to comply with 809.5, alarms shall comply with 702....
-
Maintaining Accessibility in Museum Shops
For specific information about how to comply with the ADA and reach this nearly untapped audience of people with disabilities, visit the U.S....
-
MAKING THE BUILT ENVIRONMENT ACCESSIBLE
MAKING THE BUILT ENVIRONMENT ACCESSIBLE _______________________________________________________________________________________________ The ADA's regulations and the ADA Standards...
-
11B-215.5 Residential facilities
[2010 ADAS] 215.5 Residential Facilities. Where provided in residential dwelling units required to comply with 809.5, alarms shall comply with 702....
-
1.9.1.8 Adopting agency identification
ETA Editor's Note Sections from California Building Code Chapter 1 not adopted by Division of the State Architect - Access Compliance (DSA-AC) omitted. ...
-
11B-403.5.2 Clear width at turn
Exception: Where the clear width at the turn is 60 inches (1524 mm) minimum compliance with Section 11B-403.5.2 shall not be required. FIGURE 11B-403.5.2 CLEAR WIDTH AT TURN...
-
Fixtures
For purposes of compliance with TAS 604.3.2, the reference to “fixture” shall mean the plumbing fixtures identified in TAS 213.3 and baby changing tables which are identified as convenience...
-
Gaps
However, if compliance with those measurements is not operationally or structurally feasible, operators may use bridge plates, ramps or other devices....
-
C.7.ii. - Can a federal agency provide alternate web pages for users with disabilities to supplement web pages that have innovative features which are inaccessible to assistive technologies?
be creative and innovative in the use of new technologies, Section 1194.22(k) requires that a text-only web page be provided only as a method of last resort for bringing a web site into compliance...
-
Executive Order 13132 (Federalism)
the relationship between the national government and the States, or the distribution of power and responsibilities among the various level of government; (2) imposes substantial direct compliance...
-
UNREASONABLE HARDSHIP
When the enforcing agency finds that compliance with the building standard would make the specific work of the project affected by the building standard infeasible, based on an overall evaluation...
-
12185(d) Deadline
If the President determines that compliance with the regulations issued pursuant to section 12186(a)(2)(B) of this title on or before the applicable deadlines specified in section 12186(...
-
§ 36.304(d)(3)
(3) If, as a result of compliance with the alterations requirements specified in paragraph (d)(1) and (d)(2) of this section, the measures required to remove a barrier would not be readily...
-
4. Access to Newly Constructed and Altered Facilities
Access to Newly Constructed and Altered Facilities In implementing the program, the City will ensure that all future construction and alteration work on Pedestrian Facilities will be in compliance...
-
1.9.1.8 Adopting agency identification
ETA Editor's Note Sections from the California Building Code Chapter 1 that are not adopted by Division of the State Architect - Access Compliance (DSA-AC) have been omitted....
-
§ 37.135(c)(1)
entity has met and is continuing to meet all requirements for complementary paratransit in §§37.121-37.133 of this part, the entity may submit to FTA an annual certification of continued compliance...
-
1.9.1.8 Adopting agency identification
ETA Editor's Note The remainder of California Building Code Chapter 1 is not adopted by Division of the State Architect - Access Compliance (DSA-AC), has been omitted....