Request for Comments (RFC) 4103, Real-time Transport Protocol (RTP) Payload for Text Conversation (2005), G. Hellstrom, Omnitor AB, and P....
Search Results "Specified Public Transportation"
-
E102.5 Internet Engineering Task Force (IETF)
-
[2010 ADAS] 105.1 General
Copies of the referenced standards may be inspected at the Architectural and Transportation Barriers Compliance Board, 1331 F Street, NW, Suite 1000, Washington, DC 20004; at the Department...
-
1. Evolving Approach to Covered Electronic Content
employees which contains information necessary for them to perform their job functions; or (b) an official communication by an agency or a representative of the agency to a member of the public...
-
Prohibition of Discriminatory Practices
Prohibition of Discriminatory Practices ◼ Airlines may not refuse transportation to people on the basis of disability....
-
C. Air Travelers with a Disability Changing Planes
As an employee of the delivering carrier, on request, you must provide assistance to a passenger with a disability in making flight connections and providing transportation between gates...
-
§382.3 Commuter carrier
defined in 14 CFR part 298 that carries passengers on at least 5 round trips per week on at least one route between two or more points according to its published flight schedules that specify...
-
§382.81 For which passengers must carriers make seating accommodations?
As a carrier, you must provide the following seating accommodations to the following passengers on request, if the passenger self-identifies to you as having a disability specified in this...
-
407.2.1.1 Height
Call buttons and keypads shall be located within one of the reach ranges specified in 308, measured to the centerline of the highest operable part....
-
806.2 Guest Rooms with Mobility Features
For example, closets in guest rooms must comply with the applicable provisions for storage specified in scoping....
-
302.4 Without Hearing (Section-by-Section Analysis)
This provision would clarify the requirements in existing 508 Standards §1194.31(c) and existing 255 Guidelines §1193.41(d) by specifying that provision of a mode of operation without hearing...
-
A4.27.3 Height
Electrical receptacles installed to serve individual appliances and not intended for regular or frequent use by building occupants are not required to be mounted within the specified reach...
-
Contrast
Recommendation: Although ADAAG does not specify values for light-on-dark or dark-on-light contrast, a minimum 70% light reflectance contrast is recommended....
-
Forward Approach
Forward Approach Knee and toe clearances specified for lavatories in 4.19, which recognize space for plumbing (see page 75), can be applied to sinks....
-
A4.2.3 WHEELCHAIR TURNING SPACE
This standard specifies a minimum space of 60 in (1525 mm) diameter for a pivoting 180-degree turn of a wheelchair....
-
4.27.3* HEIGHT
The highest operable part of all controls, dispensers, receptacles, and other operable equipment shall be placed within at least one of the reach ranges specified in 4.2.5 and 4.2.6....
-
16. Please indicate the composition of the trail by selecting the material(s) installed
stabilizer Soil with high organic content Crushed rock with stabilizer Crushed rock without stabilizer Engineered wood fibers Wood Chips (bark, cedar, generic) N/A Other (please specify...
-
Where Ramps and Curb Ramps are Required [§303.4]
Elevators and, under certain specified conditions, platform lifts, can be used as an alternative....
-
§ 38.113(d)(3) Exception
Where platform set-backs do not allow the horizontal gap or vertical alignment specified in paragraph (d) (1) or (2), platform or portable lifts complying with §38.125(b) of this part, or...
-
11B-703.1.1 Plan review and inspection
Signs as specified in Section 11B-703, or in other sections of this code, when included in the construction of new buildings or facilities, or when included, altered or replaced due to additions...
-
11B-806.2 Guest rooms with mobility features
For example, closets in guest rooms must comply with the applicable provisions for storage specified in scoping. ◼...
- Inclusion Solutions BigBell™ Alert System
- seca 684 r Digital Multifunctional Scale with Integrated RS232 Interface
-
Parallel Curb Ramps (R304.3) (Section-by-Section Analysis)
A minimum running slope of 5 percent and a maximum running slope of 8.3 percent are specified for parallel curb ramps, and the ramp length is limited to 4.5 meters (15 feet)....
-
Size and Spacing of Grab Bars and Handrails [4.26.2]
A gripping surface with a diameter between 1¼ to 1½ inches is specified. Alternate shapes are permitted that allow a similar opposing grip....