[ADA Title III §36.104] 2010 Standards means the 2010 ADA Standards for Accessible Design, which consist of the 2004 ADAAG and the requirements contained in subpart D of this part....
Search Results "Design Guideline"
-
[ADA Title III §36.104] 2010 Standards
-
215.3 Employee Work Areas
Where employee work areas have audible alarm coverage, the wiring system shall be designed so that visible alarms complying with 702 can be integrated into the alarm system....
-
234.4.1 Load and Unload Areas
Where load and unload areas serving existing amusement rides are newly designed and constructed, the load and unload areas shall comply with 1002.3....
-
243.1 General
Where shooting facilities with firing positions are designed and constructed at a site, at least 5 percent, but no fewer than one, of each type of firing position shall comply with 1010....
-
238.2.3 Weather Shelters
Where provided, weather shelters shall be designed and constructed so that a golf car can enter and exit the weather shelter and shall comply with 1006.4....
-
Sections 5 Through 9 (Preamble, Section-by-Section Analysis)
., Check-out Aisles, provides that, in new construction, a certain number of each design of check-out aisle, as listed in a chart based on the total number of checkout aisles of each design...
-
Workshops
Access Board prior to this project, we held two international workshops that focused on current issues of applying the anthropometric data of individuals with disability to design....
-
Sections 5 Through 9 (Section-By-Section Analysis and Response to Comments)
., Check-out Aisles, provides that, in new construction, a certain number of each design of check-out aisle, as listed in a chart based on the total number of check-out aisles of each design...
-
Paragraph (h) Non-interference with hearing technologies (Section-by-Section Analysis)
In subsequent revisions to these guidelines the Board will propose standards for RF emissions and will consider the results of the ANSI C63 Committee, if they are available, in developing...
-
Operable Parts
The carrier associations suggested that making operable parts tactilely discernible and integrating a user prompt for timeouts would require substantial time to design and test and thus...
-
Section 1193.33 Information, documentation and training [1193.25 in the NPRM] (Section-by-Section Analysis)
Several manufacturers claimed the guidelines contemplate costly training of manufacturers' employees....
-
5. Exception from the Requirements of M302 for Weight Scales with Integral Seats
One of these commenters explained that not all people with disabilities who need to transfer are wheelchair users and some wheelchair users may choose to transfer, even if the device is designed...
-
ADA Solutions, Inc. Surface Applied Truncated Dome Detectable Warning Systems
sizes: 24" x 36", 24" x 48", 24" x 60", 36" x 48" and 36" x 60" All of our truncated dome tactile surfaces are in full compliance with the American Disabilities Act Accessibility Guidelines...
-
11B-1008.3 Transfer systems
Designers should minimize the distance between the points where a child transfers from a wheelchair or mobility device and where the elevated play components are located....
-
11B-1008.3 Transfer systems
Designers should minimize the distance between the points where a child transfers from a wheelchair or mobility device and where the elevated play components are located....
-
F234.4.2 Minimum Number
structural or operational characteristics of an amusement ride are altered to the extent that the amusement ride's performance differs from that specified by the manufacturer or the original design...
-
§382.65(c)(2)
(2) The chair must be designed to be compatible with the maneuvering space, aisle width, and seat height of the aircraft on which it is to be used, and to be easily pushed, pulled, and turned...
-
‘‘Complete complaint.’’
‘‘Complete complaint’’ is defined to include all the information necessary to enable the Federal agency designated under subpart G as responsible for investigation of a complaint to initiate...
-
§ 1194.21(a)
(a) When software is designed to run on a system that has a keyboard, product functions shall be executable from a keyboard where the function itself or the result of performing a function...
-
§27.71(k)
Shared-use automated airport kiosks provided in accordance with paragraph (j) of this section must conform to the following technical accessibility standards with respect to their physical design...
-
§ 27.71(k)
Shared-use automated airport kiosks provided in accordance with paragraph (j) of this section must conform to the following technical accessibility standards with respect to their physical design...
-
Are transportation operators required to retrofit their vehicles to accommodate larger and heavier wheelchairs?
No. 49 CFR Part 38 continues to require that lifts have a minimum design load of 600 pounds and the lift platform accommodates a wheelchair measuring 30 inches by 48 inches....
-
Are transportation operators required to retrofit their vehicles to accommodate larger and heavier wheelchairs?
No. 49 CFR Part 38 continues to require that lifts have a minimum design load of 600 pounds and the lift platform accommodates a wheelchair measuring 30 inches by 48 inches....
-
12207(c)(2) "Wheelchair" defined
(2) "Wheelchair" defined For purposes of paragraph (1), the term "wheelchair" means a device designed solely for use by a mobility-impaired person for locomotion, that is suitable for...
