Where ICT conforming to one or more requirements in the Revised 508 Standards is not commercially available, the agency shall procure the ICT that best meets the Revised 508 Standards consistent...
Search Results "Fire and Safety Standard"
-
E202.7 Best Meets
-
M101.1 Purpose
The proposed standards contain technical criteria for medical diagnostic equipment that is accessible to and usable by patients with disabilities....
-
Reduced scoping for play areas and other recreation facilities. (Section-by-Section Analysis)
They have been referenced in Federal playground construction and safety guidelines and in some State and local codes and have been used voluntarily when many play areas across the country...
-
Executive Summary
The question is how does this population negotiate the built environment and what kinds of codes, standards, and guidelines exist for designers of new construction and renovations....
-
Engineered Wood Fiber
At locations where TIL was intended as the primary accessible route and EWF was used as secondary safety surfacing, the EWF particles began contaminating the TIL seams....
-
11B-202.3.1 Prohibited reduction in access
(c) If the 2010 Standards reduce the technical requirements or the number of required accessible elements below the number required by the 1991 Standards, the technical requirements or the...
-
Multiple Single-User Toilet Rooms
Where multiple single-user toilet rooms are clustered in a single location, fifty percent (50%), rather than the one hundred percent (100%) required by the 1991 Standards, are required to...
-
5.2.2.1 Transfer Surface Width Recommendations for M302
recommends 21 inches for the minimum width of the transfer surface of examination chairs and other equipment primarily used by patients in a seated position as described in its proposed standard...
-
B.3.iv - Who makes the determination that a product meets equivalent facilitation?
The vendor may assert that its product meets or exceeds the level of accessibility required by a particular standard through equivalent facilitation....
-
24.1 Q. What types of grab bars should the reinforcement be designed to accommodate and what types may be used if the builder elects to install grab bars in some units at the time of construction?
In determining what is an appropriate grab bar, builders are encouraged to look to the 1986 ANSI A117.1 standard, the standard cited in the Fair Housing Act....
-
§ 36.304(d)(2)(iii)
., elements for which there are neither technical nor scoping specifications in the 1991 Standards), and therefore those elements must be modified to the extent readily achievable to comply...
-
Alterations and Additions
This guide provides an introduction to the scoping requirements that form the basis for the Department of Justice’s 2010 ADA Standards and the Department of Transportation's ADA Standards...
-
11B-202.3.1 Prohibited reduction in access
(c) If the 2010 Standards reduce the technical requirements or the number of required accessible elements below the number required by the 1991 Standards, the technical requirements or the...
-
Enhancing Airport Wayfinding for Aging Travelers and Persons with Disabilities
The objective of this research is to develop a guidebook to help airport operators and planners assist the elderly and persons with disabilities with pedestrian wayfinding systems in standardized...
-
INTRODUCTION
These changes include revised accessibility standards, called the 2010 Standards for Accessible Design (2010 Standards), which establish minimum criteria for accessibility in design and...
-
11B-201.1 Scope
[ADA Title III] §36.406(b) Standards for New Construction and Alterations; Scope of Coverage....
-
a. The employer's judgment
the quality or quantity of work that must be performed by a person holding a job, or be required to set lower standards for the job....
-
M101.1 Purpose (Section-by-Section Analysis)
The MDE NPRM proposed that the purpose of the MDE Standards was to establish technical criteria for diagnostic equipment that is accessible to and usable by patients with disabilities and...
-
Restrooms Main Lobby
See Standards § 4.13.6. l....
-
7. APPLICABILITY
These new DoD Standards are effective immediately....
-
11B-201.1 Scope
[ADA Title III] §36.406(b) Standards for New Construction and Alterations; Scope of Coverage....
-
205 and 309 Operable Parts
205 and 309 Operable Parts Section 4.1.3, and more specifically sections 4.1.3(13), 4.27.3, and 4.27.4 of the 1991 Standards, require operable parts on accessible elements, along accessible...
-
Use of Mandatory Language in Proposed Guidelines
proposed guidelines use the mandatory language “shall” and “requirement” because the guidelines are intended to be adopted, with or without additions and modifications, as accessibility standards...
-
Use of the ISA Under the ADA
The ADA Standards apply nationwide to places of public accommodation, commercial facilities, and state and local government facilities....
