(2) Where a recipient is found to have violated this part, and where another recipient exercises control over the recipient that has violated this part, the responsible Departmental official...
Search Results "AHJ: Authority Having Jurisdiction"
Filters
Commonly Searched Documents
-
§27.11(a)(2)
-
E207.1 General
Where components of ICT are software and transmit information or have a user interface, such components shall conform to E207 and the requirements in Chapter 5....
-
B. Access Aisles
Does each accessible parking space have or share an adjacent access aisle to allow persons who use wheelchairs, walkers or other mobility aids to transfer from their car/van?...
-
608.1 General
Shower stalls that are 60 inches (1525 mm) wide and have no curb may increase the usability of a bathroom because the shower area provides additional maneuvering space....
-
§8.56(i) Voluntary compliance time limits
The recipient will have ten (10) calendar days from receipt of the formal determination of noncompliance within which to come into voluntary compliance....
-
8. Gratings
8. ...do the gratings on the sidewalks and walkways have spaces no more than 1/2" wide in the direction of travel so that canes, crutches and walkers do not slip into them, causing an individual...
-
9. Faucet Controls
Do roll-in showers have faucet controls that are easily operable with one hand (i.e.: levers, wrist blades, single arm, etc.) without tight grasping, pinching or twisting of the wrist?...
-
607.7 Bathtub Enclosures
Enclosures on bathtubs shall not have tracks installed on the rim of the open face of the bathtub....
-
1132A.3, Item 5
A pair of doors, manual or automatic, must have at least one leaf which provides a clear width of not less than 32 inches (813 mm), measured with the door positioned at an angle of 90 degrees...
-
§35.190(b)
(b) The Federal agencies listed in paragraph (b)(1)-(8) of this section shall have responsibility for the implementation of subpart F of this part for components of State and local governments...
-
Sec.36.204 Administrative methods.
A public accommodation shall not, directly or through contractual or other arrangements, utilize standards or criteria or methods of administration that have the effect of discriminating...
-
10.3.1(8)
(8) Platform edges bordering a drop-off and not protected by platform screens or guard rails shall have a detectable warning....
-
R305.1.2 Dome Spacing
The truncated domes shall have a center-to-center spacing of 41 mm (1.6 in) minimum and 61 mm (2.4 in) maximum, and a base-to-base spacing of 17 mm (0.65 in) minimum, measured between the...
-
502.3.4 Location
Access aisles shall be permitted to be placed on either side of the parking space except for angled van parking spaces which shall have access aisles located on the passenger side of the...
-
1017.8.3 Slope
Resting intervals shall have slopes not steeper than 1:48 in any direction....
-
Tandem Recumbent Bicycles
Tandem recumbent bicycles have the potential for fairly high cruising speeds due to the lower wind resistance of a recumbent combined with the additional energy output of a tandem....
-
1018.8.2 Slope
Resting intervals shall have a slope not steeper than 1:48 in any direction....
-
Do reach range requirements apply to elements or only to operable parts of elements?
Non-operable portions of elements do not have to be within accessible reach ranges....
-
APPROVED TESTING AGENCY
[HCD 1, HCD 2 & DSA-AC] Any agency, which is determined by the enforcing agency, except as otherwise provided by law, to have adequate personnel and expertise to carry out the testing...
-
1132A.3, Item 5
A pair of doors, manual or automatic, must have at least one leaf which provides a clear width of not less than 32 inches (813 mm), measured with the door positioned at an angle of 90 degrees...
-
§ 35.190(b)
(b) The Federal agencies listed in paragraph (b)(1)-(8) of this section shall have responsibility for the implementation of subpart F of this part for components of State and local governments...
-
11B-810.9 Escalators
Where provided, escalators shall comply with the sections 6.1.3.5.6 and 6.1.3.6.5 of ASME A17.1 and shall have a clear width of 32 inches (813 mm) minimum....
-
§ 38.111(a)(6)
(6) Sleeper cars shall comply with §§38.113 (b) through (d), 38.115 through 38.121, and 38.125, of this part, and have at least one compartment which can be entered and used by a person...
-
11B-1009.2.2 Seat location
The deck surface between the centerline of the seat and the pool edge shall have a slope not steeper than 1:48....