Where the elevator panel serves more than 16 openings and a parallel approach is provided, buttons with floor designations shall be permitted to be 54 inches (1372 mm) maximum above the...
Search Results "Feasibility (Technical, Infeasible, Structural, Maximum Extent)"
-
11B-407.4.6.1 Location
-
1132A.6 Closer-effort to operate doors
Maximum effort to operate doors shall not exceed 8½ pounds (38 N) for exterior doors and 5 pounds (22 N) for interior doors, such pull or push effort being applied at right angles to hinged...
-
11B-604.9.6 Dispensers
Toilet paper dispensers shall comply with Section 11B-309.4 and shall be 7 inches (178 mm) minimum and 9 inches (229 mm) maximum in front of the water closet measured to the centerline of...
-
11B-705.1.2.2.1 Perpendicular curb ramps
Detectable warnings shall extend the full width of the ramp run less 2 inches (51 mm) maximum on each side, excluding any flared sides....
-
11B-604.9.1 Location
The centerline of the water closet shall be 12 inches (305 mm) minimum and 18 inches (457 mm) maximum from the side wall or partition, except that the water closet shall be 17 inches (432...
-
Sioux Chief DropKick™ Offset Flange 889-45PAM
Full-flow, 3" I.D. throat – no restriction Solvent welds inside 3" Sch. 40 fitting hub Corrosion-resistant 430 stainless steel swivel ring is engineered for maximum strength Black...
-
Sioux Chief FullFlush™ Offset Flange 889-AOM
½" offset in any direction for closet bowl setting Corrosion-resistant 430 stainless steel swivel ring is engineered for maximum strength Black...
-
National Amputation Foundation
Whenever feasible, an amputee member of our organization who has returned to a normal life, visits the new amputee. This has proven to be a real morale builder....
-
Council of Citizens with Low Vision International (CCLVI)
To promote research to prevent blindness, improve maximum utilization of sight, and improve environmental conditions and access for low vision people....
-
Symmons Diav Two Handle Lavatory Faucet SLW-3512-1.5
Symmons Diav Two Handle Lavatory Faucet Model SLW-3512-1.5 The European design of the Symmons Diav Collection was inspired by modern industrial structures....
-
American Specialties Snap Flange Concealed Mounting Grab Bar 3700-Series
Available peened or smooth Mandrell bending process ensures uniform bar diameters Heliarc welding forms a single Structural unit...
-
[F] 907.4.2.2 Height
The height of the manual fire alarm boxes shall be a minimum of 42 inches (1067 mm) and a maximum of 48 inches (1219 mm) measured vertically, from the floor level to the activating handle...
-
11B-604.7 Dispensers
Toilet paper dispensers shall comply with Section 11B-309.4 _|Operation|_ and shall be 7 inches (178 mm) minimum and 9 inches (229 mm) maximum in front of the water closet measured to the...
-
407.12.3.2.2 Knee and Toe Space
Knee and toe space under ICT shall be 27 inches (685 mm) high minimum, 25 inches (635 mm) deep maximum, and 30 inches (760 mm) wide minimum and shall be clear of obstructions....
-
M101.5 Dimensions
Dimensions that are not stated as “maximum” or “minimum” are absolute....
-
M307.4 Operating Force
The force required to activate operable parts shall be 5 pounds (22.2 N) maximum....
-
407.4.8.2.3 Frequency
The verbal annunciator shall have a frequency of 300 Hz minimum to 3000 Hz maximum....
-
11B-703.2.6 Stroke thickness
Stroke thickness of the uppercase letter “I” shall be 15 percent maximum of the height of the character....
-
11B-407.4.8.2.3 Frequency
The verbal annunciator shall have a frequency of 300 Hz minimum to 3000 Hz maximum....
-
703.2.6 Stroke Thickness
Stroke thickness of the uppercase letter "I" shall be 15 percent maximum of the height of the character....
-
703.2.6 Stroke Thickness
Stroke thickness of the uppercase letter “I” shall be 15 percent maximum of the height of the character....
-
407.4.8.2.3 Frequency
The verbal annunciator shall have a frequency of 300 Hz minimum to 3000 Hz maximum....
-
R407.3 Cross Slope
The cross slope of ramp runs shall be 2 percent maximum....
-
R304.4.1 Running Slope
The running slope of blended transitions shall be 5 percent maximum....
