Section 1193.31 Accessibility and usability (Section-by-Section Analysis) This section provides that, subject to section 1193.21, manufacturers must design, develop and fabricate their...
Search Results "Universal Design"
Filters
Commonly Searched Documents
-
Section 1193.31 Accessibility and usability (Section-by-Section Analysis)
-
Section 36.406(f)(2)
This rule, which is designed to prevent a public accommodation from placing wheelchair spaces and companion seats on one side of the facility only, is consistent with the Department’s enforcement...
-
Q7: Curb Ramp for a Sidewalk that is Not Made of Concrete or Asphalt
Regardless of the materials used to construct the pedestrian walkway, if the intent of the design was to provide access to pedestrians, then curb ramps must be incorporated where an altered...
-
1132A.8 Hand-activated door hardware
locking doors that are hand-activated and on an accessible route shall be operable with a single effort by lever-type hardware, panic bars, push-pull activating bars or other hardware designed...
-
Lines of Sight at Dining Areas in Sports Venues
Designers called attention to dining areas integrated into the seating bowl of sports venues that are tiered in order to provide adequate lines of sight....
-
Height
This will allow a design professional to increase the guardrail height if a specific location needs enhanced safety measures or a local building code applies....
-
Research Projects
The Board’s research program is focused on the study of accessibility relating to architecture and design, communication, and transportation....
-
Research Projects
The Board’s research program is focused on the study of accessibility relating to architecture and design, communication, and transportation....
-
Transfer Height
Where possible, designers are encouraged to locate the transfer device seat within 17 to 19 inches above the load and unload surface....
-
1.2 MDE Advisory Committee Membership
Table 1.2 lists the 24 organizations selected; each organization could designate a primary representative and a secondary representative who would participate in the absence of (or at the...
-
R304.5.3 Cross Slope
Pedestrian street crossings without yield or stop control are crossings where there is no yield or stop sign, or where there is a traffic signal that is designed for the green phase....
-
R101.1 General
Compliance with this document is mandatory when required by regulations issued by federal agencies that include accessibility standards for the design, construction, and alteration of pedestrian...
-
"1991 Standards" and "2004 ADAAG" (Section-by-Section Analysis)
The term "1991 Standards" refers to the currently enforceable ADA Standards for Accessible Design, codified at 28 CFR part 36, App. A. ...
-
J. Valet Parking and New Parking Garage
construct accessible parking spaces, entrances, and routes of travel as required by 2010 Standards §§ 208.1, 208.2, 208.2.4, 208.3.1, and 502.1-503.5, and to erect appropriate signage designating...
-
"1991 Standards" and "2004 ADAAG" (Section-by-Section Analysis)
The term "1991 Standards" refers to the currently enforceable ADA Standards for Accessible Design, codified at 28 CFR part 36, App. A. ...
-
ADA Requirements - Wheelchairs, Mobility Aids, and Other Power-Driven Mobility Devices
These requirements, or rules, clarify and refine issues that have arisen over the past 20 years and contain new, and updated, requirements, including the 2010 Standards for Accessible Design...
-
Sec.36.401(d)(1)(ii)(B)
The facility housing a "shopping center or shopping mall'' only includes floor levels housing at least one sales or rental establishment, or any floor level designed or intended for use...
-
Research Projects
The Board’s research program is focused on the study of accessibility relating to architecture and design, communication, and transportation....
-
Shared Use Paths
A shared use path is a multi-use path that is designed primarily for use by pedestrians and bicyclists for transportation and recreational purposes....
-
Outdoor Conditions [4.8.8]
Exterior ramps must be designed so that water does not accumulate on the ramp or landing surface. A slope up to 2% is allowed at landings for adequate drainage....
-
Measuring Opening Force
While there are instruments specifically designed for this purpose (e.g., tensionometer), a device as simple as a spring-loaded plunger or "fish" scale is effective in measuring the force...
-
Equivalent Facilitation [2.2]
This provides flexibility for new technologies and innovative designs solutions that may not have been taken into account when ADAAG was developed....
-
Definitions
“Accessible on Election Day” means that a polling place is compliant with the 2010 ADA Standards for Accessible Design (“2010 Standards”) on Election Day, whether such compliance is...