Benches must have a clear floor space positioned to allow persons using wheelchairs or other mobility devices to approach parallel to the short end of a bench seat....
Search Results "Court Floor Holding Cell"
Filters
Commonly Searched Documents
-
Benches
-
404.2.10 Door and Gate Surfaces
Swinging door and gate surfaces within 10 inches (255 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
Transfer Access [1014.2.1]
The camp shelter floor at the entrance or opening must be no higher than 19 inches when measured from the clear ground space....
-
404.2.10 Door and Gate Surfaces
Swinging door and gate surfaces within 10 inches (255 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
11B-604.4 Seats
The seat height of a water closet above the finish floor shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum measured to the top of the seat....
-
11B-604.4 Seats
The seat height of a water closet above the finish floor shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum measured to the top of the seat....
-
11B-604.4 Seats
The seat height of a water closet above the finish floor shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum measured to the top of the seat....
-
Panda TS.83 Thermally Broken Multi-Slide Door System
It can be either surface mounted on the finish floor or set directly on the subfloor for an even, recessed finish....
-
Library of Congress That All May Read
Handicapped, Library of Congress, is a free library service for people with temporary or permanent low vision, blindness, or other physical disabilities that prevent them from reading or holding...
-
Benches
Ensure that the front edge of the bench seat is 17 to 19 inches (430 to 485 millimeters) above the ground or floor space....
-
Section 36.208 Direct Threat (Preamble, Section-by-Section Analysis)
This paragraph codifies the standard first applied by the Supreme Court in School Board of Nassau County v....
-
3. The Release Provisions are Overbroad
rules, or regulations, if applicable] concerning any of the Settling Defendant’s Facility (ies) that have been or could have been brought or asserted in this action, in any action in any court...
-
34. Does an employer have to allow an employee with a disability to work at home as a reasonable accommodation?
Courts have differed regarding whether "work-at-home" can be a reasonable accommodation. Compare Langon v. Department of Health and Human Servs., 959 F.2d 1053, 1060, 2 AD Cas....
-
Integration
The Supreme Court's decision in Olmstead v. L.C., illustrates the broad reach of the integration mandate....
-
III. IMPLEMENTATION AND ENFORCEMENT
unable to reach a satisfactory resolution of the issue or issues raised within 30 days of the date it provides notice to Lewisboro, it may institute a civil action in federal district court...
-
11B-903.5 Height
The top of the bench seat surface shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the finish floor or ground....
-
708.4 Residential Dwelling Unit Communication Systems
Communications systems between a residential dwelling unit and a site, building, or floor entrance shall comply with 708.4....
-
903.5 Height
The top of the bench seat surface shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the finish floor or ground....
-
306.3.2 Maximum Depth
Knee clearance shall extend 25 inches (635 mm) maximum under an element at 9 inches (230 mm) above the finish floor or ground....
-
306.3.2 Maximum Depth
Knee clearance shall extend 25 inches (635 mm) maximum under an element at 9 inches (230 mm) above the finish floor or ground....
-
903.5 Height
The top of the bench seat surface shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the finish floor or ground....
-
409.4.4 Leveling
Each car shall automatically stop at a floor landing within a of 1/2 inch (13 mm) under rated loading to zero loading conditions....
-
5.1.4 Transfer Surface Height Measurement
The transfer surface height should be measured from the floor to the highest point on the seat in an uncompressed state, inclusive of bolsters....
-
T304.2 Height
Operable parts shall be located 24 inches (610 mm) minimum and 48 inches (1220 mm) maximum above the floor of non-rail vehicles....
