The tops of tray slides shall be 28 inches (711 mm) minimum and 34 inches (864 mm) maximum above the finish floor or ground....
Search Results "Court Floor Holding Cell"
Filters
Commonly Searched Documents
-
11B-904.5.2 Tray slides
-
11B-902.4.2 Height
The tops of tables and counters shall be 26 inches (660 mm) minimum and 30 inches (762 mm) maximum above the finish floor or ground....
-
11B-707.7.1 Visibility
The display screen shall be visible from a point located 40 inches (1016 mm) above the center of the clear floor space in front of the machine....
-
11B-409.4.4 Leveling
Each car shall automatically stop at a floor landing within a tolerance of ½ inch (12.7 mm) under rated loading to zero loading conditions....
-
11B-902.4.2 Height
The tops of tables and counters shall be 26 inches (660 mm) minimum and 30 inches (762 mm) maximum above the finish floor or ground....
-
11B-904.5.2 Tray slides
The tops of tray slides shall be 28 inches (711 mm) minimum and 34 inches (864 mm) maximum above the finish floor or ground....
-
412.2.6 Accessibility
[DSA-AC] In air traffic control towers, an accessible route shall not be required to serve the cab and the equipment areas on the floor immediately below the cab....
-
Panda TS.83 Thermally Broken Multi-Slide Door System
It can be either surface mounted on the finish floor or set directly on the subfloor for an even, recessed finish....
-
Library of Congress That All May Read
Handicapped, Library of Congress, is a free library service for people with temporary or permanent low vision, blindness, or other physical disabilities that prevent them from reading or holding...
-
Benches
Ensure that the front edge of the bench seat is 17 to 19 inches (430 to 485 millimeters) above the ground or floor space....
-
Section 36.208 Direct Threat (Preamble, Section-by-Section Analysis)
This paragraph codifies the standard first applied by the Supreme Court in School Board of Nassau County v....
-
3. The Release Provisions are Overbroad
rules, or regulations, if applicable] concerning any of the Settling Defendant’s Facility (ies) that have been or could have been brought or asserted in this action, in any action in any court...
-
34. Does an employer have to allow an employee with a disability to work at home as a reasonable accommodation?
Courts have differed regarding whether "work-at-home" can be a reasonable accommodation. Compare Langon v. Department of Health and Human Servs., 959 F.2d 1053, 1060, 2 AD Cas....
-
Integration
The Supreme Court's decision in Olmstead v. L.C., illustrates the broad reach of the integration mandate....
-
III. IMPLEMENTATION AND ENFORCEMENT
unable to reach a satisfactory resolution of the issue or issues raised within 30 days of the date it provides notice to Lewisboro, it may institute a civil action in federal district court...
-
11B-903.5 Height
The top of the bench seat surface shall be 17 inches (432 mm) minimum and 19 inches (483 mm) maximum above the finish floor or ground....
-
708.4 Residential Dwelling Unit Communication Systems
Communications systems between a residential dwelling unit and a site, building, or floor entrance shall comply with 708.4....
-
903.5 Height
The top of the bench seat surface shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the finish floor or ground....
-
306.3.2 Maximum Depth
Knee clearance shall extend 25 inches (635 mm) maximum under an element at 9 inches (230 mm) above the finish floor or ground....
-
306.3.2 Maximum Depth
Knee clearance shall extend 25 inches (635 mm) maximum under an element at 9 inches (230 mm) above the finish floor or ground....
-
903.5 Height
The top of the bench seat surface shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the finish floor or ground....
-
409.4.4 Leveling
Each car shall automatically stop at a floor landing within a of 1/2 inch (13 mm) under rated loading to zero loading conditions....
-
5.1.4 Transfer Surface Height Measurement
The transfer surface height should be measured from the floor to the highest point on the seat in an uncompressed state, inclusive of bolsters....
-
T304.2 Height
Operable parts shall be located 24 inches (610 mm) minimum and 48 inches (1220 mm) maximum above the floor of non-rail vehicles....
