[F] 907.4.2.2 Height. ...
Search Results "Transfer Surface Height"
-
[F] 907.4.2.2 Height
-
Check-Out Aisles and Sales and Service Counters
Where the counter is a single-height counter, this requirement applies across the entire depth of the counter top....
-
M303.2.4.2.2 Height
Between 9 inches (230 mm) and 27 inches (685 mm) above the floor, the knee clearance shall be permitted to reduce at a rate of 1 inch (25 mm) in depth for every 6 inches (150 mm) in height...
-
Plan 6B: 12-Foot Wide Accessible Guest Room
Features include a transfer shower, water closet length (rim to rear wall) 24 inches maximum, comparable vanity, wardrobe, and door connecting to adjacent guest room....
-
[F] 907.4.2.2 Height
The height of the manual fire alarm boxes shall be not less than 42 inches (1067 mm) and not more than 48 inches (1219 mm) measured vertically, from the floor level to the highest point...
-
[F] 907.4.2.2 Height
The height of the manual fire alarm boxes shall be not less than 42 inches (1067 mm) and not more than 48 inches (1219 mm) measured vertically, from the floor level to the highest point...
-
Pressalit Care VALUE Support Arm Fixed Height Swing Grab Bar
Support arm Incl. fixing kit for brick wall Basic material: Steel Surface material: Rilsan End cap: Nylon (PA) Provides firm support when you are sitting, standing, or transferring...
-
M301.4 Lift Compatibility
Diagnostic equipment shall be usable with portable patient lifts and, when in use with such lifts, shall comply with M301.4.1 or M301.4.2. EXCEPTION: Where fixed overhead patient...
-
M301.4 Lift Compatibility
Diagnostic equipment shall be usable with a patient lift and shall comply with M301.4.1 or M301.4.2.
-
Adjustable height/gap protocol
Adjustable height/gap protocol: From the initial setup, a gap separating the device and platform was introduced with the plywood blocks of 3.5” (8.9cm) and then the height of platform was...
-
Addendum C: Participant responses to two step transfers for protocols D and E
Transfer/Avoid Felt more comfortable transferring to a direct vertical height instead of the angled transfer....
-
Plan 6A: 12-Foot Wide Accessible Guest Room
Features include a transfer shower, water closet length (rim to rear wall) 24 inches maximum, comparable vanity, clothes closet with swinging door, and door connecting to adjacent guest...
-
Murdock Manufacturing Grab Bars
Grab bar is 1-1/2 inch (3.81 cm) diameter satin finish stainless steel and have 1-1/2 inch (3.81 cm) clearance to wall. Grab bars are designed to support a load of at least 250...
-
Comfort Designs Comfort Care™ Grab Bars
Now you don’t have to compromise strength for warmth or softness for durability. With ComfortCare™ you can get it all with a lifetime warranty. Properly installed as original...
-
711.4.4 Ducts and air transfer openings
Penetrations of horizontal assemblies by ducts and air transfer openings that are not required to have dampers shall comply with this section....
-
Willoughby Industries WRS-BF-FA Front Mounted Recessed Shower Panel With Hand Held Flexshower Head
Head Front mounted, recessed shower panel shall be: Willoughby Model No.WRS-BF-FA Shower panel shall be fabricated from 14 gauge, type 304 stainless steel with exposed stainless surfaces...
-
11B-224.7 Housing at a place of education
and clustered sleeping rooms) or on floors containing accessible sleeping rooms with mobility features shall provide turning spaces that comply with Section 11B-809.2.2 and kitchen work surfaces...
-
ADA Revised Requirements: Ticket Sales
The Department of Justice published revised final regulations implementing the Americans with Disabilities Act (ADA) for title II (State and local government services) and...
-
Sloped Surfaces
Measuring the slope of a ramp, parking space, pedestrian route, or other ground or floor surface is important to identify whether the surface is accessible....
-
A Wheelchair Rider's Guide to the California Coast
Explore, enjoy, protect. Rolling across the sand in a beach wheelchair Fishing from an accessible pier Hiking an accessible trail or...
-
6.1 Deliberative Process
An initial Committee decision was to recommend adjustable height transfer surfaces, and this 17” to 19” range for the minimum height was consistent with the NPRM....
-
T402.8.1 Deployment to Roadways or to Curb Height Boarding and Alighting Areas
The running slope of ramps and bridgeplates used for deployment to the roadway or to curb-height boarding and alighting areas shall be 1:6 maximum, as measured to ground level with the non-rail...
