Pole-supported pedestrian traffic-control buttons shall be identified with color coding consisting of a textured horizontal yellow band 2 inches (51 mm) in width encircling the pole, and...
Search Results "Curb Ramp Width"
-
11B-703.7.2.7 Pedestrian traffic-control buttons
-
M305.2.3 Height
EXCEPTION: Where the width of the transfer surface for imaging beds exceed 24 inches (610 mm), the tops of the gripping surfaces shall be permitted to be 3 inches (75 mm) minimum and 6 inches...
-
1016.6 Openings
Where possible, drainage grates should be located outside the minimum clear width of the outdoor recreation access route....
-
Court Sports
Accessible routes must comply with all ADAAG requirements, such as width and changes in level or surface, and must directly connect both sides of the court....
-
704.8.2 First story
The unoccupied space shall be on the same lot or dedicated for public use, shall not be less than 30 feet (9144 mm) in width, and shall have access from a street by a posted fire lane in...
-
407.3.3 Numeric Keys
Some keypads will have a double width zero key and decimal key instead of the asterisk and pound signs found on a telephone keypad. These examples conform to this provision....
-
Clear Floor Space [4.19.3]
Additional width is required where the clear floor space is obstructed on both sides more than 2 feet (see page 17)....
-
1016.6 Openings
Where possible, drainage grates should be located outside the minimum clear width of the outdoor recreation access route....
-
1015.3 Viewing Space
The viewing space is required to be 32 inches maximum and 51 inches minimum high above the ground and extend the full width of the clear ground space....
-
11B-703.7.2.7 Pedestrian traffic-control buttons
Pole-supported pedestrian traffic-control buttons shall be identified with color coding consisting of a textured horizontal yellow band 2 inches (51 mm) in width encircling the pole, and...
- Inpro Corporation JointMaster® 925 Fire Barrier System Expansion Joint Systems
-
5.4.2.2 Transfer and Positioning Support Length Recommendations for Imaging Equipment with Transfer Surfaces
recommendation A transfer support (for transfer surfaces less than or equal to 24” deep) is to extend horizontally along the side of the patient scanning/imaging table at least the minimum width...
-
4.9.4 HANDRAILS
Figure 19 Stair Handrails (2) If handrails are not continuous, they shall extend at least 12 in (305 mm) beyond the top riser and at least 12 in (305 mm) plus the width of...
-
Station 2-Three-Point Turn
Designers can use this information to select shared use path widths and, if necessary, build wider turnaround areas, so that users can execute U-turns within the confines of the path....
-
§ 36.304(c)(1)
These measures include, for example, installing an entrance ramp, widening entrances, and providing accessible parking spaces....
-
Sec.36.304(c)(1)
These measures include, for example, installing an entrance ramp, widening entrances, and providing accessible parking spaces....
-
4.1.7(1)(b)
(b) The Advisory Council shall determine, on a case-by-case basis, whether provisions required by part 4 for accessible routes (exterior and interior), ramps, entrances, toilets, parking...
-
§ 38.159(a)(2) Exception
If portable or station-based lifts, ramps or bridge plates meeting the applicable requirements of this section are provided at stations or other stops required to be accessible under regulations...
-
§ 38.171(b)
This provision does not require that inaccessible vehicles be retrofitted with lifts, ramps or other boarding devices....
-
11B-1003.3.1 Boat slip clearance
In existing piers, clear pier space shall be permitted to be located perpendicular to the boat slip and shall extend the width of the boat slip, where the facility has at least one boat...
-
1003.3.1 Boat Slip Clearance
In existing piers, clear pier space shall be permitted to be located perpendicular to the boat slip and shall extend the width of the boat slip, where the facility has at least one boat...
-
II. Rulemaking History
The 2007 draft also proposed to decrease the maximum running slope of vehicle ramps to 1:8 (as compared to the existing guidelines, which specify a range of ramp slopes from 1:4 to 1:12,...