Bus stop boarding and alighting areas shall have a firm, stable surface....
Search Results "Wheel Stop"
Commonly Searched Documents
- 
    
  
  11B-810.2.1 Surface
  
- 
    
  
  Recumbent Bicycles
  Two-wheeled recumbents can be difficult to learn to balance, especially those with under-seat steering.... 
- 
    
  
  Symbols: ADA Standard Section 407.4.7.1.3
  Section 407.4.7.1.3 covers the current ADA Standards for the designation and indicator symbols on elevator car control buttons. 
- 
    
  
  11B-810.6.3 Station names
  It is also important to place signs at intervals in the station where passengers in the vehicle will be able to see a sign when the vehicle is either stopped at the station or about to come... 
- 
    
  
  11B-411.4.8.2.1 Signal type
  The signal shall be an automatic verbal annunciator which announces the floor at which the car is about to stop.... 
- 
    
  
  11B-407.4.7.1.3 Symbols
  The control button for the emergency stop, alarm, door open, door close, main entry floor, and phone, shall be identified with raised symbols and Braille as shown in Table 11B-407.4.7.1.3... 
- 
    
  
  § 38.23(c)(2) Ramp surface
  surface shall be continuous and slip resistant; shall not have protrusions from the surface greater than 1/4 inch high; shall have a clear width of 30 inches; and shall accommodate both four-wheel... 
- 
    
  
  § 38.83(c)(2) Ramp surface
  surface shall be continuous and slip resistant, shall not have protrusions from the surface greater then 1/4 inch, shall have a clear width of 30 inches, and shall accommodate both four-wheel... 
- 
    
  
  Section 5 References
  Section 5 References i http://udeworld.com/analysis-of-seat-height-for-wheeled-mobility-devices ii ”The Impact of Transfer Setup on the Performance of Independent Transfers: Final... 
- 
    
  
  § 38.95(c)(2) Ramp surface
  surface shall be continuous and slip resistant, shall not have protrusions from the surface greater than 1/4 inch high, shall have a clear width of 30 inches and shall accommodate both four-wheel... 
- 
    
  
  § 38.125(c)(2) Ramp surface
  surface shall be continuous and slip resistant, shall not have protrusions from the surface greater than 1/4 inch high, shall have a clear width of 30 inches and shall accommodate both four-wheel... 
- 
    
  
  Data Deficiencies
  While general information can be found regarding average height of wheeled mobility devices, and people’s ability to transfer, data is not available regarding the needs of people of short... 
- 
    
  
  Resting Intervals [1017.8]
  Resting intervals are level areas that provide an opportunity for people to stop after a steep segment and recover before continuing on.... 
- 
    
  
  § 38.159(c)(2) Ramp surface
  continuous and slip resistant; shall not have protrusions from the surface greater than 1/4 inch (6.5 mm) high; shall have a clear width of 30 inches (760 mm); and shall accommodate both four-wheel... 
- 
    
  
  References:
  IDeA Center Study at the University of Buffalo, New York: Summary analysis of wheelbase measurements on wheeled mobility devices.... 
- 
    
  
  Leveling: ADA Standard Section 409.4.4
  Section 409.4.4 covers the ADA Standards for the self-leveling feature in private residence elevators. 
- 
    
  
  11B-409.4.4 Leveling
  Each car shall automatically stop at a floor landing within a tolerance of ½ inch (12.7 mm) under rated loading to zero loading conditions.... 
- 
    
  
  11B-405.9.2 Curb or barrier
  To prevent wheel entrapment, the curb or barrier shall provide a continuous and uninterrupted barrier along the length of the ramp.... 
- 
    
  
  Recommendations
  Recommendations Based on the data in Table 1 and the observations above, we recommend: a minimum flat surface of 40 in. length for platforms accommodating wheeled mobility devices... 
- 
    
  
  Manual Wheelchairs
  Manual wheelchairs have a seat between two rear wheels usually about 600 mm (24 inches) in diameter. The 75-mm to 200- mm (3- to 8-inch) front wheels swivel to allow for easy steering.... 
- 
    
  
  Significant alternatives which minimize any significant economic impacts on small entities
  Maximum cross slope of 2 percent required on pedestrian access routes, including within pedestrian street crossings with yield or stop control.... 
- BraunAbility Millenium 2 Wheelchair Lift for School Buses, Cutaway Buses, and Paratransit Vans
- 
    
  
  Features of Accessible Parking Spaces
  If the accessible route is located in front of the parking space, install wheel stops to keep vehicles from reducing the clear width of the accessible route below 36 inches. 3.... 
- 
    
  
  Knee and Toe Clearance (M303.2.4)
  The Wheeled Mobility Anthropometry Project showed that these dimensions do not accommodate many people in the sample and recommended alternative dimensions that would accommodate 95 percent... 
