The height of the lowest end of the gripping surface on vertical standing supports shall be 34 inches (865 mm) minimum and 37 inches (940 mm) maximum above the standing surface....
Search Results "Support Rail"
Filters
Commonly Searched Documents
-
M305.3.2.2 Vertical Position
-
11B-307.4.1 Guy braces
Where a guy support is used within either the width of a circulation path or 24 inches maximum outside of a circulation path, a vertical guy brace, sidewalk guy or similar device shall be...
-
ADA and Level Boarding - Q&A on Wheelchairs and Bus and Rail Service
DEPARTMENT OF TRANSPORTATION DISABILITY LAW GUIDANCE
-
49 CFR Part 37 - Transportation for Individuals With Disabilities at Intercity, Commuter, and High Speed Passenger Railroad Station Platforms; Miscellaneous Amendments
DEPARTMENT OF TRANSPORTATION 49 CFR Parts 37 and 38 [Docket OST–2006–23985] RIN 2105–AD54 Transportation for Individuals With Disabilities at Intercity, Commuter, and...
-
8. Transportation Vehicles
These requirements apply to new or remanufactured vehicles covered by the ADA, including: buses and vans rail cars (rapid, light, commuter, intercity, high-speed, and monorail...
-
§ 38.175(a)
(a) All cars for high-speed rail systems, including but not limited to those using “maglev” or high speed steel-wheel-on-steel rail technology, and monorail systems operating primarily on...
-
§ 37.47(a)
(a) Each public entity that provides designated public transportation by means of a light or rapid rail system shall make key stations on its system readily accessible to and usable by individuals...
-
"Doing work'' or "performing tasks.'' (Section-by-Section Analysis)
The Department agrees with this statement but cautions that unless the animal is individually trained to do something that qualifies as work or a task, the animal is a pet or support animal...
-
Doing "work'' or "performing tasks.'' (Section-by-Section Analysis)
The Department agrees with this statement but cautions that unless the animal is individually trained to do something that qualifies as work or a task, the animal is a pet or support animal...
-
Transfer Supports Location and Configuration M301.3 and M302.3
Transfer Supports Location and Configuration M301.3 and M302.3 Location of the transfer supports shall be a minimum of 6 inches to a maximum of 19 inches from the top of the transfer...
-
M301.3 Supports (Section-by-Section Analysis)
An editorial change was made to this section as a result of the change in M301.3.2, described below, to replace the word “stirrups” with the term “leg supports.”...
-
4.4.3 Backrest and Armrest
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device or supporting...
-
12162(e)(2) Existing stations
(2) Existing stations
-
§ 38.63(a) Requirement
(a) Requirement. Suitable devices or systems shall be provided to prevent, deter or warn individuals from inadvertently stepping off the platform between cars. Acceptable solutions...
-
§ 38.63 Between-car barriers
[See subsections ...]
-
§ 38.71(c)
(c) If portions of the vehicle are modified in a way that affects or could affect accessibility, each such portion shall comply, to the extent practicable, with the applicable...
-
§ 38.71(b)
(b)
-
§ 38.85 Between-car barriers
Where vehicles operate in a high-platform, level-boarding mode, devices or systems shall be provided to prevent, deter or warn individuals from inadvertently stepping off the...
-
§ 38.71 General
[See subsections ...]
-
§ 38.51 General
[See subsections ...]
-
§ 38.111(a)
(a) New, used and remanufactured intercity rail cars, to be considered accessible by regulations in part 37 of this title shall comply with this subpart to the extent required for each type...
-
M301.3.3 Head and Back Support (Section-by-Section Analysis)
In the MDE NPRM the Access Board proposed to place the requirements for head and back support for diagnostic equipment used by patients in the supine, prone, or side-lying position in M301...
-
Detectable Warnings
Rail platform requirements include specifications for detectable warnings along platform boarding edges not protected by screens or guards (810.5.2)....
-
Positioning Supports Considered
The Board is considering requiring in the final standards positioning supports such as rails, bars, or panels with handholds to be provided along the sides of diagnostic equipment used by...