A seat shall be provided in shower stalls 36 in by 36 in (915 mm by 915 mm) and shall be as shown in Fig. 36....
Search Results "Hand-Held Shower Unit"
Filters
Commonly Searched Documents
-
4.21.3 SEAT
-
1134A.6 Showers
Showers required to be accessible shall comply with this section....
-
11B-608.2.2.1 Clearance
A 36 inch (914 mm) wide minimum by 60 inch (1524 mm) long minimum clearance shall be provided adjacent to the open face of the shower compartment. [2010 ADAS] 608.2.2.1 Clearance....
-
11B-608.2.2.1 Clearance
A 36 inch (914 mm) wide minimum by 60 inch (1524 mm) long minimum clearance shall be provided adjacent to the open face of the shower compartment....
-
Requirement 6. Reinforced walls for grab bars.
that covered multifamily dwellings with a building entrance on an accessible route shall be designed and constructed in such a manner that all premises within covered multifamily dwelling units...
-
608.2.3 Alternate Roll-In Type Shower Compartments
608.2.3 Alternate Roll-In Type Shower Compartments....
-
Residential Dwelling Units with Communication Features: ADA Standard Section 233.3.1.2
Section 233.3.1.2 covers scoping requirements in the current ADA Standards for residential dwelling units with communication features.
-
4.8 Outdoor Rinsing Showers
[See subsections ...]
-
MULTI-BEDROOM HOUSING UNIT
[DSA-AC] A housing unit, intended for use by students at a place of education, with a kitchen and/or toilet and bathing rooms within the unit, such as an apartment, or dormitory....
-
Excel Dryer, Inc. CAST Cover Series HANDS ON® Push Button Activated Hand Dryers and Hair Dryers
Features Hands On® dryers utilize a maintenance free brushless motor, capacitor initiated for quick starts....
-
11B-809 Residential dwelling units
[See subsections ...]
-
11B-610.3.1 Rectangular seats
The rear edge of a rectangular seat shall be 2½ inches (64 mm) maximum and the front edge 15 inches (381 mm) minimum and 16 inches (406 mm) maximum from the seat wall. The side edge...
-
iStorm Hand Dryer Informational Video
-
11B-608.2.1 Reserved
ETA Editor's Note The transfer type shower compartments prescribed by 2010 ADAS 608.2.1 are not recognized as an accessible shower in California....
-
608.2.3 Alternate Roll-In Type Shower Compartments
Alternate roll-in type shower compartments shall be 36 inches (915 mm) wide and 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
-
11B-809.10.6.4 Reinforcement for grab bars
Reinforcement for grabs bars shall comply with the following: Continuous reinforcement shall be installed in the walls of showers 30 inches (762 mm) maximum to 38 inches (965 mm) minimum...
-
Speedflow Hand Dryer
No need to recess the unit into the wall. ADA Surfaced mounted. Also helps to qualify for LEED Credits, being GreenSpec listed....
-
1. Number of Roll-in Showers
If there are more than 50 guestrooms/suites in the facility, are the proper number of accessible rooms with roll-in showers provided per table 9.1.2 below....
-
Curbs [4.21.7]
Curbs [4.21.7] Curbs are limited to ½ inch (measured from the room floor and the shower floor) so as not to interfere with entry to the shower....
-
Florestone 35-62H Barrier-Free Shower
ADA COMPLIANT* CALIFORNIA ADA COMPLIANT* Note: Units sold in CA DO NOT come with a slide bar. Instead a stationary wall hook will be installed per CA-ADA requirements (2008)....
-
Residential Dwelling Units with Communication Features: ADA Standard Section 809.5
Residential dwelling units required to provide communication features shall comply with 809.5....
-
11B-608.2.3 Alternate roll-in type shower compartments
11B-608.2.3 Alternate roll-in type shower compartments....
-
Tile Redi Free® Barrier Free Base and Flash Installation Video
Redi Base shower pan installation...
-
11B-608.2.3 Alternate roll-in type shower compartments
Alternate roll-in type shower compartments shall be 36 inches (914 mm) wide and 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
