A 36 inch (914 mm) wide minimum by 60 inch (1524 mm) long minimum clearance shall be provided adjacent to the open face of the shower compartment. [2010 ADAS] 608.2.2.1 Clearance....
Search Results "Fixed Shower Head"
-
11B-608.2.2.1 Clearance
-
11B-608.2.2.1 Clearance
A 36 inch (914 mm) wide minimum by 60 inch (1524 mm) long minimum clearance shall be provided adjacent to the open face of the shower compartment....
-
Fixed Seating and Tables
Fixed Seating and Tables If tables are provided, such as in restaurants and snack bars, and the tables are attached to the wall or floor (fixed), then 5% of the tables or at least one...
-
c. ii.
Ensure that at least 5% of the fixed table seating but not less than one table is accessible to wheelchair users in the Spy City Café. See Standards § 5.1....
-
G. Other types of equipment and furniture
individuals with disabilities, including pool chairs that permit individuals who use wheelchairs to enter a pool with a sloped entrance without submerging their personal wheelchair and shower...
-
§27.5 Head of Operating Administration
Head of Operating Administration means the head of an operating administration within the Department (U.S....
-
608.2.3 Alternate Roll-In Type Shower Compartments
608.2.3 Alternate Roll-In Type Shower Compartments....
-
4.32.1 Minimum Number
Fixed or built-in seating or tables required to be accessible by 4.1 shall comply with 4.32....
-
4.32.1 MINIMUM NUMBER
Fixed or built-in seating, tables, or work surfaces required to be accessible by 4.1 shall comply with 4.32....
-
608.5 Controls
Controls, faucets, and shower spray units shall comply with 309.4....
-
C2-2. Undersides of Exterior Stairs
Are the undersides of exterior stairs enclosed or protected with a cane detectable barrier so that people who are blind or have low vision will not hit their heads on the underside?...
-
4.8 Outdoor Rinsing Showers
[See subsections ...]
-
11B-809.10.6.1 Size
When one or more shower stalls are provided within the same dwelling unit, as least one shower stall shall comply with one of the following: A transfer type shower compartment...
-
11B-610.3.1 Rectangular seats
The rear edge of a rectangular seat shall be 2½ inches (64 mm) maximum and the front edge 15 inches (381 mm) minimum and 16 inches (406 mm) maximum from the seat wall. The side edge...
-
11B-610.3.1 Rectangular seats
The rear edge of a rectangular seat shall be 2½ inches (64 mm) maximum and the front edge 15 inches (381 mm) minimum and 16 inches (406 mm) maximum from the seat wall. The side edge...
-
Location of Controls
Comments indicated that this specification was not consistent with a corresponding figure showing the location on the side closest to the shower opening. Response....
-
11B-608.2.1 Reserved
ETA Editor's Note The transfer type shower compartments prescribed by 2010 ADAS 608.2.1 are not recognized as an accessible shower in California....
-
B. Legal foundation for equipment and furniture coverage
and furniture that are not fixed....
-
4. Shower Wand
Is there an adjustable height hand-held shower wand with at least a 60" long hose provided so persons who bathe from a seated position may wash and rinse with the directional spray?...
-
608.2.3 Alternate Roll-In Type Shower Compartments
Alternate roll-in type shower compartments shall be 36 inches (915 mm) wide and 60 inches (1525 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
-
11B-809.10.6.6 Controls
Controls and operating mechanisms shall comply with Section 11B-309.4.
-
11B-809.10.6.6 Controls
Controls and operating mechanisms shall comply with Section 11B-309.4.
-
Curbs [4.21.7]
Curbs [4.21.7] Curbs are limited to ½ inch (measured from the room floor and the shower floor) so as not to interfere with entry to the shower....
-
1. Number of Roll-in Showers
If there are more than 50 guestrooms/suites in the facility, are the proper number of accessible rooms with roll-in showers provided per table 9.1.2 below....