Exception: Exterior signs that are not located at the door to the space they serve shall not be required to comply with Section 11B-703.2....
Search Results "General Exception"
Commonly Searched Documents
-
11B-216.2 Designations
-
1630.6(a)
(a) In general....
-
1630.2(n)(1)
(1) In general, the term essential functions means the fundamental job duties of the employment position the individual with a disability holds or desires....
-
Paragraph (i) Hearing aid coupling (Section-by-Section Analysis)
Hearing aid coupling (Section-by-Section Analysis) No substantive comments were received on this provision and no changes were made, other than the editorial revisions discussed in the general...
-
Subpart E—Enforcement (Preamble, Section-by-Section Analysis)
Section 36.503 describes the procedures for suits by the Attorney General set out in section 308(b)(1)(B) of the Act....
-
1630.2(g)(3)
(See section 1630.3 for exceptions to this definition)....
-
E101.3 Conventional Industry Tolerances
Dimensions are subject to conventional industry tolerances except where dimensions are stated as a range....
-
C101.3 Conventional Industry Tolerances
Dimensions are subject to conventional industry tolerances except where dimensions are stated as a range....
-
4.1.3 ACCESSIBLE HOUSING
Accessible housing shall comply with the requirements of 4.1 and 4.34 except as noted below:...
-
§1630.2(g) Disability
(g) Definition of “disability”— Note to paragraph (g): See §1630.3 for exceptions to this definition....
-
Valet Parking and Mechanical Access Parking Garages
The 1991 Standards contained an exception that exempted valet parking facilities from providing accessible parking spaces. The 2010 Standards eliminate this exception....
-
Top Landings
However, a similar exception has been added for alterations. Under this exception, 1:12 maximum side flares are required where there is no landing at the top of curb ramps....
-
M303.2.2 Width (Section-by-Section Analysis)
However, the Board added a new exception for wheelchair spaces on raised platforms, as discussed in Section IV.C.1....
-
Technical Memorandum TM 2012-04 Multi-Story Buildings and Facilities
TM 2012-04 Multi-Story Buildings and Facilities: Effective Date: November 15, 2012 2012 TAS Reference: 206.2.3, Exception 1 – Private Buildings and Facilities The following...
-
Technical Memorandum TM 2012-07 Press Boxes
TM 2012-07 Press Boxes Effective Date: January 22, 2013 2012 TAS Reference: 206.2.7, Exception 1 and 2 The following clarifications are provided to address references to...
-
401.1 Scope (Section-by-Section Analysis)
Assistive technology hardware would be excepted from conformance with this chapter....
-
809 Residential Dwelling Units
In some cases, the Board determined that scoping or technical provisions applicable to facilities generally were sufficient without the addition of language specific to residential facilities...
-
Subpart B -- Technical Standards (Formerly Subpart B -- Accessibility Standards in the NPRM) (Preamble, Section-by-Section Analysis)
Subpart B of the proposed rule contained four sections: §1194.21 (General Requirements); §1194.23 (Component Specific Standards); §1194.25 Standards for Compatibility; and §1194.27 (Functional...
-
Elevated: ADA Standard Section 1008.2.4.2
EXCEPTIONS: 1....
-
Vision Lights: ADA Standard Section 404.2.11
Section 404.2.11 covers the current ADA Standards for vision lights on manual doors and gates.
-
Seats: ADA Standard Section 604.4
Section 604.4 covers the current ADA Standards for the water closet seats.
-
Flush Controls: ADA Standard Section 604.6
Section 604.6 covers the current ADA Standards for water closets flush controls.
-
Height: ADA Standard Section 606.3
Section 606.3 covers the current ADA Standards for the height of lavatories and sinks.
-
Grab Bars: ADA Standard Section 607.4
Section 607.4 covers the current ADA Standards for bathtub grab bars.