Terms not listed in Section 11B-106.5 and not defined in Chapter 2, Section 202, but specifically defined in a referenced standard, shall have the specified meaning from the referenced standard...
Search Results "AHJ: Authority Having Jurisdiction"
-
11B-106.2 Terms defined in referenced standards
-
§35.130(g)
exclude or otherwise deny equal services, programs, or activities to an individual or entity because of the known disability of an individual with whom the individual or entity is known to have...
-
11B-703.8.12 Protective covering
Where a protective layer is placed over VMS characters through which the VMS characters must be viewed, the protective covering shall have a non-glare finish....
-
E207.1 Software (Section-by-Section Analysis)
E207.1 Software (Section-by-Section Analysis) This section proposes that components of ICT that transmit information or have a user interface—such as are firmware, platforms, or software...
-
Sides of Curb Ramps [4.7.5]
Where pedestrians cross the ramp, curb ramps are required to have side flares; sharp returns present tripping hazards....
-
STRUCTURAL IMPRACTICABILITY
Changes having little likelihood of being accomplished without removing or altering a load-bearing structural member and/or incurring an increased cost of 50 percent or more of the value...
-
1.1 Objectives
The primary objectives of this project are to determine whether various detectable warning materials are visually detectable by pedestrians who have visual impairments and to provide recommendations...
-
§ 35.151(b)(4)(v)(A)
obligation to provide an accessible path of travel may not be evaded by performing a series of small alterations to the area served by a single path of travel if those alterations could have...
-
§ 38.101(a)
(a) Any stepwell or doorway with a lift, ramp or bridge plate shall have, when the door is open, at least 2 footcandles of illumination measured on the step tread, ramp, bridge plate, or...
-
§ 35.130(g)
exclude or otherwise deny equal services, programs, or activities to an individual or entity because of the known disability of an individual with whom the individual or entity is known to have...
-
11B-609.2.1 Circular cross section
Grab bars with circular cross sections shall have an outside diameter of 1¼ inches (32 mm) minimum and 2 inches (51 mm) maximum....
-
11B-703.8.12 Protective covering
Where a protective layer is placed over VMS characters through which the VMS characters must be viewed, the protective covering shall have a non-glare finish....
-
11B-106.2 Terms defined in referenced standards
Terms not listed in Section 11B-106.5 and not defined in Chapter 2, Section 202, but specifically defined in a referenced standard, shall have the specified meaning from the referenced standard...
-
§ 38.153(b)
(b) All step edges shall have a band of color(s) running the full width of the step which contrasts from the step tread and riser, either dark-on-light or light-on-dark....
-
Section 406.8
status quo with respect to detectable warnings in pedestrian facilities, the Department is adding a provision (not found in the current version of the new ADAAG) requiring curb ramps to have...
-
2) Valet parking
2) Valet parking ADAAG: Facilities with valet parking must have an accessible passenger loading zone on an accessible route to the exterior of the facility (§4.1.2(5)(e))....
-
11B-106.2 Terms defined in referenced standards
Terms not listed in Section 11B-106.5 and not defined in Chapter 2, Section 202, but specifically defined in a referenced standard, shall have the specified meaning from the referenced standard...
-
604.8.2.1 Size
Ambulatory accessible compartments shall have a depth of 60 inches (1525 mm) minimum and a width of 35 inches (890 mm) minimum and 37 inches (940 mm) maximum....
-
407.2.1 Call Controls
EXCEPTION: Existing elevators shall be permitted to have recessed call buttons....
-
903.3 Size
Benches shall have seats that are 42 inches (1065 mm) long minimum and 20 inches (510 mm) deep minimum and 24 inches (610 mm) deep maximum....
-
505.7.1 Circular Cross Section
Handrail gripping surfaces with a circular cross section shall have an outside diameter of 1¼ inches (32 mm) minimum and 2 inches (51 mm) maximum....
-
Mockett DH4 Slim Cylindrical Door Handle
Round bar and posts have a soft contemporary look and classic style....
-
Mockett DH2A/BB-SSS Curved Door Handle Back to back Small
DESCRIPTION Small bow door handles have a hefty feel and grip, defined by their solid construction and fine craftsmanship. Stately arcing bow design suitable for any door type....
-
TrueForm 24" ADA Floating Concrete Sink FLO-24-ADA
• This sink does not have an overflow hole. • Diameter of faucet holes are 1 3/8". • Made from start to finish by skilled craftsmen in the USA....
