or part of a facility constructed by, on behalf of, or for the use of a recipient shall be designed and constructed in such manner that the facility or part of the facility is readily accessible...
Search Results "TAS: Texas Accessibility Standards"
-
§104.23(a) Design and construction
-
1018.7.2 Cross Slope
This section requires the cross slope of beach access routes to not be steeper than 1:48....
-
6.7.2 Cross Slope
The cross slope of a beach access route shall be no more than 1:33 (3 percent)....
-
Are employee restrooms and break rooms required to be accessible?
Yes, spaces used by employees for purposes other than work, including restrooms, break rooms, locker rooms, lounges, and parking must be fully accessible....
-
The A11Y Project
The A11Y Project is a community-driven effort to make web accessibility easier. ...
-
410.1 General
Platform lifts shall comply with ASME A18.1 (1999 edition or 2003 edition) (incorporated by reference, see "Referenced Standards" in Chapter 1)....
-
410.1 General
Platform lifts shall comply with ASME A18.1 (1999 edition or 2003 edition) (incorporated by reference, see "Referenced Standards" in Chapter 1)....
-
§ 38.123(b)
(b) Restrooms required to be accessible shall be in close proximity to at least one seating location for persons using mobility aids complying with §38.125(d) of this part and shall be connected...
-
Recreation Site Layout
Accessibility is, of course, one of the many design parameters for any recreation site....
-
Where Required: Multi-Story Buildings and Facilities [§206.2.3]
Where Required: Multi-Story Buildings and Facilities [§206.2.3] An accessible route must connect each story and mezzanine in a facility unless an exception applies....
-
4.1.2(5)(e) Valet parking
(e)* Valet parking: Valet parking facilities shall provide a passenger loading zone complying with 4.6.6 located on an accessible route to the entrance of the facility....
-
4.1.1(6)
bathing units clustered at a single location; however, at least one toilet unit complying with 4.22 or one bathing unit complying with 4.23 should be installed at each location whenever standard...
-
A MINIMUM HIGHEST POINT STANDARD OF 19 INCHES IS CONSISTENT WITH EXISTING ACCESSIBILITY STANDARDS
A MINIMUM HIGHEST POINT STANDARD OF 19 INCHES IS CONSISTENT WITH EXISTING ACCESSIBILITY STANDARDS Current accessibility standards and regulations generally consider a transfer surface...
-
11B-213.3.1 Toilet compartments
213.3.1 Toilet compartments Corrects drafting error in prior code adoption to require that the fixture count for determining when additional accessible...
-
Accessible Cells in Detention and Correctional Facilities (Section-by-Section Analysis)
The lack of sufficient accessible cells is further demonstrated by complaints received by the Department. ...
-
11B-604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1524 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1422 mm) deep minimum for wall hung water closets and...
-
11B-604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1524 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1422 mm) deep minimum for wall hung water closets and...
-
A. Accessible Voting Program
If remediation as listed on Attachment 1 or relocation to an accessible facility is impossible, as agreed to by the United States, then County agrees to comply with title II’s program accessibility...
-
11B-411.2.1.3.1 Keypad call console arrangement
The accessibility function button shall be located directly below the keypad at a height of 36 inches (914 mm) to 42 inches (1067 mm) above the finish floor....
-
11B-411.2.1.3.1 Keypad call console arrangement
The accessibility function button shall be located directly below the keypad at a height of 36 inches (914 mm) to 42 inches (1067 mm) above the finish floor....
-
11B-411.2.1.3.1 Keypad call console arrangement
The accessibility function button shall be located directly below the keypad at a height of 36 inches (914 mm) to 42 inches (1067 mm) above the finish floor....
-
11B-233.3.3 Additions
required to comply with Sections 11B-233.3.1.1 _|Residential Dwelling Units with Mobility Features|_ and 11B-233.3.1.2 _|Residential Dwelling Units with Adaptable Features|_ shall be on an accessible...
-
11B-233.3.3 Additions
required to comply with Sections 11B-233.3.1.1 _|Residential Dwelling Units with Mobility Features|_ and 11B-233.3.1.2 _|Residential Dwelling Units with Adaptable Features|_ shall be on an accessible...
