This chapter contains scoping and technical requirements for accessibility to sites, facilities, buildings, and elements by individuals with disabilities....
Search Results "Non-Fixed Element"
-
11B-101.1 General
-
11B-101.1 General
This chapter contains scoping and technical requirements for accessibility to sites, facilities, buildings, and elements by individuals with disabilities....
- Magnuson Group RETTO Outdoor Waste Receptacle
- HEWI System 100 Door Hardware
- Kompan, Inc. ELE400020 - Stinger Spring Rider
- Kompan, Inc. ELE400019 - Speeder Spring Rider
-
4.3.4 Knee and Toe Clearances
The crease of the foot and lower leg in contact with the built element (Dorsal foot point as reference); 3....
-
Re: Single User Restroom Accessibility
Section 11B-202.3.2 indicates that "an alteration of an existing element, space, or area of a building or facility shall not impose a requirement for accessibility greater than new construction...
-
608.4 Seats
A folding or non-folding seat shall be provided in transfer type shower compartments....
-
232.5.1 Cubicles and Counters
EXCEPTION: The inmate or detainee side of cubicles or counters at non-contact visiting areas not serving holding cells or housing cells required to comply with 232 shall not be required...
-
407.4.8.2.1 Signal Type
[ECTCR UFAS 4.10.13] EXCEPTION: For elevators other than destination-oriented elevators that have a rated speed of 200 feet per minute (1 m/s) or less, a non-verbal audible signal with...
-
R302.7.4 Flangeway Gaps
Flangeway gaps at pedestrian at-grade rail crossings shall be 64 mm (2.5 in) maximum on non-freight rail track and 75 mm (3 in) maximum on freight rail track....
-
608.4 Seats
A folding or non-folding seat shall be provided in transfer type shower compartments....
-
407.4.8.2.1 Signal Type
EXCEPTION: For elevators other than destination-oriented elevators that have a rated speed of 200 feet per minute (1 m/s) or less, a non-verbal audible signal with a frequency of 1500 Hz...
-
R103.3 Units of Measurement
Combining values from the two systems may result in non-compliance....
-
E202.6.1 Required Documentation
The Federal Acquisition Regulation (FAR) sets forth the documentation requirements for a determination of commercial non-availability by federal agencies subject to 508 requirements....
-
13.18 Quality Assurance Inspections
previously-identified standards issues) utilizing each Brand’s quality assurance checklists to verify appearance of items that can be checked in an average half-day review with a visible, non-intrusive...
-
11B-812.7.1 Location
Exception: Where four or fewer total EVCS are provided within a facility, the access aisle for non-angled van accessible spaces may be located on either the driver or passenger side of the...
- Pilot Rock FSW-30 Campfire Ring
-
4.21.3 Seat
Where a fixed seat is provided in a 30 in by 60 in minimum (760 mm by 1525 mm) shower stall, it shall be a folding type and shall be mounted on the wall adjacent to the controls as shown...
-
Additional Service
For example, no one is precluded from offering service in a larger service area, during greater hours than the fixed route system, or without charge....
-
Running Slope of Ramps Deployed to Roadways or Curb-Height Bus Stops
Indeed, such buses had increasingly become public transit agencies’ vehicle of choice for fixed-route bus service.10 In the 2010 NPRM, the Access Board thus proposed to update the ramp...
-
Play Component
An element intended to generate specific opportunities for play, socialization, or learning....
-
Using the Tape Measure
A tape measure is used to measure the length, width, height, and depth of various elements including parking spaces and access aisles, routes, thresholds, doorways, and protruding objects...