Spaces and elements within employee workstations shall only be required to comply with Sections 11B-207.1 _|Accessible Means of Egress; General|_, 11B-215.3 _|Fire Alarm Systems; Employee...
Search Results "Clear Space"
Filters
Commonly Searched Documents
-
11B-203.9 Employee workstations
-
11B-812.8.1 Four or fewer
Where four or fewer total EVCS are provided, identification with an International Symbol of Accessibility (ISA) and signs identifying van accessible spaces shall not be required....
-
5.8.2.1 Height of Breast Platform at Time of Measurement
Rationale for the recommendation The shape of the breast platform affects the shape of the knee and toe space....
-
11B-503.5 Vertical clearance
Vehicle pull-up spaces, access aisles serving them, and a vehicular route from an entrance to the passenger drop-off and loading zone and from the passenger drop-off and loading zone to...
-
Additional Clearance: ADA Standard Section 306.2.4
Section 306.2.4 covers the current ADA Standards for additional clearances for toe space.
-
4.20.2 Floor Space
4.20.2 Floor Space....
-
Lavatory & Accessory Layouts
The trash receptacle is preferred to be near the door to allow people to pull the door open with a paper towel and drop it into the receptacle before exiting.
-
3. Exception to Ramp Running Slope
The MDE Advisory Committee, during its discussion of wheelchair spaces on weight scales, extensively addressed the permissible slopes of ramps on raised platforms....
-
Guidelines for Requirement 4
The Department has adopted the Option One guidelines for Requirement 4 with the following changes: First, the Department has eliminated the specification for maneuvering space if a person...
-
4.2 Physical Accessibility Barriers and Solutions
Barriers Solutions Simple/Low cost Involved / High cost Parking spaces are too narrow Use cones and/or tape and temporary signs to mark...
-
11B-609.3 Spacing
The space between the wall and the grab bar shall be 1½ inches (38 mm). The space between the grab bar and projecting objects below and at the ends shall be 1½ inches (38 mm) minimum....
-
Ticketing (Assembly areas, not parking.)
Title II Regulations 28 § 35.138 Ticketing: (a) (1) For the purposes of this section, “accessible seating” is defined as wheelchair spaces and companion seats that comply with...
-
M303.1 General
Diagnostic equipment used by patients seated in a wheelchair shall comply with M303.
-
M303.3.1 Vertical
Changes in level of ¼ inch (6.4 mm) high maximum shall be permitted to be vertical.
-
M303.3.2 Beveled
Changes in level between ¼ inch (6.4 mm) high and ½ inch (13 mm) high maximum shall be beveled with a slope not steeper than 1:2.
-
M303.4 Components
Where components of diagnostic equipment are used to examine specific body parts, the components shall be capable of examining the body parts of a patient seated in a wheelchair....
-
F202.6.5.5 Assembly Areas
Assistive listening systems shall comply with F219 and assembly seating shall comply with F221.
-
M303.4 Components (Section-by-Section Analysis)
The MDE NPRM proposed to require diagnostic equipment used by patients seated in a wheelchair which has components that are used to examine specific body parts, be capable of...
-
M303.1 General (Section-by-Section Analysis)
This is an introductory section.
-
Key Features of Accessible Stadiums
[See subsections ...]
-
T208 Passenger Access Routes
[See subsections ...]
-
T605 Seat Belts and Shoulder Belts
[See subsections ...]
-
A2
A2. Is the vehicle pull-up area relatively level (1:50 or 2% maximum slope in all directions)? Yes No
-
A4.8.2 Slope and Rise
Ramp slopes between 1:16 and 1:20 are preferred. The ability to manage an incline is related to both its slope and its length. Wheelchair users with disabilities affecting their arms...