Boarding piers at boat launch ramps shall provide clear pier space 60 inches (1524 mm) wide minimum and shall extend the full length of the boarding pier....
Search Results "Clear Floor Area"
Filters
Commonly Searched Documents
-
11B-1003.3.2 Boarding pier clearances
-
11B-206.2.2 Within a site
An accessible route is required to connect to the boundary of each area of sport activity....
-
206.2.2 Within a Site
An accessible route is required to connect to the boundary of each area of sport activity....
-
11B-206.2.2 Within a site
An accessible route is required to connect to the boundary of each area of sport activity....
-
11B-206.2.2 Within a site
An accessible route is required to connect to the boundary of each area of sport activity....
-
Section 36.406(f) Assembly Areas (Section-by-Section Analysis)
Section 36.406(f) Assembly Areas (Section-by-Section Analysis) In the NPRM, the Department proposed Sec. 36.406(f) to supplement the assembly area requirements of the 2004 ADAAG, which...
-
Figure 407.2.3.1 Floor Designations on Jambs of Elevator Hoistway Entrances – Drawing from the U.S. Access Board
-
221.1 General
Assembly areas shall provide wheelchair spaces, companion seats, and designated aisle seats complying with 221 and 802. In addition, lawn seating shall comply with 221.5....
-
§ 38.123(a)(5)
(5) Doorways on the end of the enclosure, opposite the water closet, shall have a minimum clear opening width of 32 inches....
-
11B-503.5 Vertical clearance
The minimum vertical clearance at designated passenger drop-off and loading zones, and along at least one vehicle access route to the area from site entrances and exits, is 114 inches....
-
Play Components: ADA Standard Section 1008.4
Ground level play components on accessible routes and elevated play components connected by ramps shall comply with 1008.4.
-
11B-1008.4 Play components
Ground level play components on accessible routes and elevated play components connected by ramps shall comply with Section 11B-1008.4.
-
Access Board: Standard Roll In Shower Stalls
This video is part of a longer animation produced by the U.S. Access Board. View the animation video in its entirety on the Access Board's website...
-
Exit Stairway Enclosures [IBC §1007.3 and 1019 (2003), §1003.2.13.2 and 1005.3.2 (2000)]
The IBC contains requirements for exit stairway enclosures that address fire-resistance and smoke protection, stairways and handrails, signs, and other features. The ADA...
-
11B-221.2 Wheelchair spaces
Wheelchair spaces complying with Section 11B-221.2 shall be provided in assembly areas with fixed seating. ...
-
11B-221.2 Wheelchair spaces
Wheelchair spaces complying with Section 11B-221.2 shall be provided in assembly areas with fixed seating....
-
11B-206.2.1 Site arrival points
(1) Newly constructed or altered streets, roads, and highways must contain curb ramps or other sloped areas at any intersection having curbs or other barriers to entry from a street...
-
Dumpster Enclosure
Just as an FYI, Texas has a Technical Memorandum that briefly addresses dumpster enclosures. It is TM 2013-21.
-
Expert Report of Jeromy G. Murphy, American Construction Investigations, LTD (August 6, 2018)
Building Entrance: One side of the double leaf doors at the designated accessible entrance does not provide at least 32 inches clear passage width when the door is open 90 degrees (1991...
-
Minimum Requirement
Minimum Requirement ADAAG requires permanently installed ALSs in those assembly areas where audible communication is integral to the use of a space (movie theaters, concert and lecture...
-
CHAPTER 5: DOORWAYS, CIRCULATION PATHS AND FARE COLLECTION DEVICES
[See subsections ...]
-
T402.3 Installation and Operation
When used for boarding and alighting, ramps and bridgeplates shall be firmly attached to the non-rail vehicle to prevent displacement. Ramps and bridgeplates provided on large...
-
CHAPTER 4: BOARDING AND ALIGHTING
[See subsections ...]
