These dimensions are: (A) occupied width, the horizontal distance between the side-most (lateral-most) points of the wheelchair or occupant on the right and left side; (B) occupied length...
Search Results "Viewing Distance"
Filters
Commonly Searched Documents
-
Clear Floor Space: Minimum Clear Floor Space Required for Forward and Side Approach - Power Chair
-
Cross Slope
This may be expressed as the percentage of change in elevation or as a ratio of vertical distance to horizontal distance....
-
Accessible Slopes
If the distance is greater than 2 inches, the ramp is too steep. For example, if the distance is 3 inches, then the slope is 1:8 (3:24 = 1:8 which is a steeper slope than 1:12). ...
-
703.3.1 Dimensions and Capitalization
Measurement Range Minimum in Inches Maximum in Inches Dot base diameter 0.059 (1.5 mm) to 0.063 (1.6 mm) Distance...
-
Locating Controls & Devices: Percent of People Who Can Reach the Matrix Cell Indicated While Holding 5 lb Weight - Forward Approach Power Chair
percentage of users able to retrieve and place a 5 lb weight on a target shelf in the forward reach direction for a given (a) height from the floor (shown the vertical axis) and (b) offset distance...
-
Locating Controls & Devices: Percent of People Who Can Reach the Matrix Cell Indicated While Holding 5 lb Weight - Forward Approach Manual Wheelchair
percentage of users able to retrieve and place a 5 lb weight on a target shelf in the forward reach direction for a given (a) height from the floor (shown the vertical axis) and (b) offset distance...
-
INTERNATIONAL SYMBOL OF ACCESSIBILITY
It is a graphic representation of the profile view of a wheelchair with occupant. See Chapter 11B, Figure 11B-703.7.2.1. ◼...
-
Sales Counters [7.2(1)]
Recommendation:Travel distances between counters and facility size should be considered where not all counters are accessible. (ADAAG does not specify maximum travel distances)....
-
Display Screens
requirement that the display screen be visible from a point located 40 inches above the center of the clear floor space essentially means that the display screen must not be obscured from view...
-
Appendix A to Part 382—Report of Disability-Related Complaint Data
View or download PDF (page 1) View or download PDF (page 2)...
-
Grohe Allure Two-Hole Basin Mixer S-Size Faucet
StarLight® finish Set for final installation for Requires Vessel Rough-In Valve 33 780 Wall mount With metal plate Spout with flow control 7 1/6" (180 mm) spout Center distance...
-
Running Slope
This may be expressed as the percentage of change in elevation (grade) or as a ratio of vertical distance to horizontal distance (running slope)....
-
Sloped Surfaces
While the level is in this position, measure the distance between the bottom end of the level and the sloped surface below....
-
704.5 Fire-resistance rating
The fire-resistance rating of exterior walls with a fire separation distance of greater than 5 feet (1524 mm) shall be rated for exposure to fire from the inside....
-
Spout Location [4.15.3]
Since rounded or oval bowls may not have a "front edge," a three inch distance is specified; the entire trajectory does not have to be within this distance....
-
Check-Out Aisles [7.3]
Clear passage must be at least 36 inches wide continuously and 32 inches at a point (24 inch maximum distance). Access can be provided at aisles shared between two check-outs....
-
703.3.1 Dimensions and Capitalization
703.3.1 Braille Dimensions Measurement Range Minimum in Inches Maximum in Inches Dot base diameter 0.059 (1.5 mm) to 0.063 (1.6 mm) Distance...
-
16(a)(ii)
(if the hotel offers more than one room with a premium view at a higher cost), one room on the executive level (if the hotel has an executive level), and one smoking room (if the hotel...
-
11B-812.5.1 Accessible route to building or facility
Exception: EVCS complying with Section 11B-812 shall be permitted to be located in different EV charging facilities if substantially equivalent or greater accessibility is provided in terms of distance...
-
11B-1008.2.4.2 Elevated
Exceptions: The clear width of accessible routes connecting elevated play components shall be permitted to be reduced to 32 inches (813 mm) minimum for a distance of 24 inches (610...
-
1. Sloped Surfaces
While the level is in this position, measure the distance between the end of the level and the sloped surface below....
-
TownSteel TDV3316 Door Viewer For 1-3/8" Door Thickness
TDV3316 is UL certified door viewers. 200 degree view area....
-
TownSteel TDV3315 Door Viewer For 1-3/4" Door Thickness
TDV3315 is UL certified door viewers. 200 degree view area....
-
11B-703.3.1 Dimensions and capitalization
between two dots in the same cell1 0.100 (2.5 mm) Distance between corresponding dots in adjacent cells1 0.300 (7.6 mm)...
