Required clear floor spaces, clearance at fixtures, and turning space shall be permitted to overlap....
Search Results "Turn Lane"
Commonly Searched Documents
-
11B-603.2.2 Overlap
-
603.2.2 Overlap
Required clear floor spaces, clearance at fixtures, and turning space shall be permitted to overlap....
-
603.2.2 Overlap
Required clear floor spaces, clearance at fixtures, and turning space shall be permitted to overlap....
-
603.2.2 Overlap
Required clear floor spaces, clearance at fixtures, and turning space shall be permitted to overlap....
-
11B-603.2.2 Overlap
Required clear floor spaces, clearance at fixtures, and turning space shall be permitted to overlap....
-
603.2.2 Overlap
Required clear floor spaces, clearance at fixtures, and turning space shall be permitted to overlap....
-
6.3(1)
(1) Each bedroom shall have a turning space that complies with 4.2.3, and preferably that is located near the entrance....
-
11B-603.2.2 Overlap
Required clear floor spaces, clearance at fixtures, and turning space shall be permitted to overlap....
-
§ 38.29(a)
(a) Interior handrails and stanchions shall permit sufficient turning and maneuvering space for wheelchairs and other mobility aids to reach a securement location from the lift or ramp....
-
Resting Intervals [1016.8]
A turning space that complies with section 304.3.2 of the ABA Standards must be provided....
- Bobrick Accessibility Video -- Design for Turning Radiuses
-
11B-705.1.2.2.2.2 Two entrance/exit points
Where the turning space has two entrance/exit points other than the sloped ramp segments, detectable warnings shall be 36 inches (914 mm) deep at both entrance/ exit points, as measured...
-
241 and 612 Saunas and Steam Rooms
241 and 612 Saunas and Steam Rooms Section 241 of the 2010 Standards sets scoping for saunas and steam rooms and section 612 sets technical requirements including providing accessible turning...
-
243 Shooting Facilities with Firing Positions
243 Shooting Facilities with Firing Positions Sections 243 and 1010 of the 2010 Standards require an accessible turning space for each different type of firing position at a shooting...
-
Is turning space required in all rooms and spaces?
Turning space is required in certain spaces, such as toilet and bathing facilities, dressing and fitting rooms, and transient lodging guest rooms....
-
Maneuvering Space Where Ramps are Provided
Maneuvering Space Where Ramps are Provided At least one maneuvering space must be provided on the same level as the play component. The space must have a slope no steeper than 1:48...
-
11B-813.2.10 Door swing
A door, in any position, shall be permitted to encroach into the turning space by 12 inches (305 mm) maximum....
-
Water Hydrants
The surface at the base of water hydrants at recreation areas must be firm and stable with a 60-inch turning radius. See the "Surfaces" rule of thumb above....
-
3.4.4 Clear Ground Space and Turning Space
have a clear ground or floor space 36 inches (915 mm) minimum by 48 inches (1220 mm) minimum positioned for either forward or parallel approach to the viewing location and at least one turning...
-
1014.2.2 Roll-in Access
The section also requires a turning space complying with 304.3 of the Architectural Barriers Act Accessibility Guidelines to be provided within the camp shelter....
-
Appropriate clear floor space
There needs to be adequate turning space within the cell -- either a 60-inch-diameter circle or a T-shaped turn area....
-
Error/Omission: Food service queuing areas are too narrow and do not provide adequate clear width for turns.
Error/Omission: Food service queuing areas are too narrow and do not provide adequate clear width for turns....
-
Maneuvering Space in Load and Unload Areas
Sections 234.2 and 1002.3 of the 2010 Standards require that a level wheelchair turning space be provided at the load and unload areas of each amusement ride....
-
Approach
Approach Turning space (60-inch diameter or T-shaped space) for a wheelchair must be provided where the accessible route adjoins the ride, so that riders can access the ride....