supports are part of a rail system that needs to fold and store out of the way and therefore require more space to articulate....
Search Results "Hybrid Surface System"
-
M305.2.1 Location (Section-by-Section Analysis)
-
B. M301 Diagnostic Equipment Used by Patients in a Supine, Prone, or Side-lying Position and M302 Diagnostic Equipment Used by Patients in a Seated Position
Therefore, the Significant Changes Section addresses the transfer surface and lift compatibility requirements for M301 and M302 together....
-
406.2.7 Electric vehicle charging stations and systems
Where provided, electric vehicle charging systems shall be installed in accordance with the California Electrical Code and the California Green Building Standards Code....
-
Portlight Inclusive Disaster Strategies
Portlight Strategies, Inc. is a 501(c)(3) organization, founded in 1997 to facilitate a variety of projects involving people with disabilities, including post-disaster relief work....
-
5.4.2 Transfer Support Length for M301 and M302
The purpose of a minimum length is to ensure that there is a minimum gripping surface available to support positioning and repositioning during a transfer....
-
Emergency Preparedness Tool Kit For People with Disabilities
Emergency Preparedness Tool Kit For People with Disabilities Oregon Office on Disability & Health (OODH) Oregon Institute of Disability & Development (OIDD) Center on...
-
Issue: Effective Communication
must provide appropriate auxiliary aids and services for people with disabilities (e.g., qualified interpreters, notetakers, computer-aided transcription services, assistive listening systems...
-
III. Costs and Benefits
The Department estimates that the costs associated with this final rule will be minimal for two reasons. First, modifications to policies, practices, and procedures, if needed by an...
-
11B-812.9 Surface marking
EVCS vehicle spaces shall provide surface marking stating “EV CHARGING ONLY” in letters 12 inches (305 mm) high minimum....
-
M305.2.3 Height
During use, the tops of transfer support gripping surfaces shall be 6 inches (150 mm) minimum and 19 inches (485 mm) maximum higher than the top of the associated uncompressed transfer surface...
-
11B-812.9 Surface marking
EVCS vehicle spaces shall provide surface marking stating “EV CHARGING ONLY” in letters 12 inches (305 mm) high minimum....
-
Section G: Ramps
(§405.7.4) G8 If the rise of the ramp is greater than 6", are handrails provided that are between 34" and 38" above the ramp surface?...
-
5.4.1 Transfer Support Location for M301 and M302
Provisions require transfer supports be provided for use with the transfer sides and be located within reach of the transfer surface and not obstruct transfer onto the surface when in position...
-
Ramps M303:3.3, 3.3.1, 3.3.2
with drop offs ½ inch or greater would be required to provide edge protection 2 inches high minimum on each side to prevent users from inadvertently travelling off the sides of the ramped surface...
-
406.2.7 Electric vehicle charging stations and systems
Where provided, electric vehicle charging systems shall be installed in accordance with the California Electrical Code and the California Green Building Standards Code....
-
Compartment: ADA Standard Section 409.4.7.3
Section 409.4.7.3 covers the current ADA Standards for the emergency communication system compartment in private residence elevators.
-
Handrails [§405.8, §505]
Handrail Height and Clearance Handrail Continuity and Extensions Surface requirements and clearances facilitate a power grip along the length of handrails....
-
1133A.1 General
(2) 30" minimum countertop for work surface with removable base cabinet and finish flooring beneath; 30" x 48" minimum clear floor space to allow parallel or forward approach....
-
5.4.9 Interruptions along Transfer Support Gripping Recommendation for M301 and M302
At the point of connection, these features impede the ability to grasp completely around the cross section of the gripping surface....
-
M305.2.1 Location
Transfer supports shall be located within reach of the transfer surface and shall not obstruct transfer onto or off of the surface when in position....
-
FIGURE 11A-10A KITCHEN SPECIFICATIONS
(2) 30" minimum countertop for work surface with removable base cabinet and finish flooring beneath; 30" x 48" minimum clear floor space to allow parallel or forward approach....
-
Stairway Handrails Requirements in the ADA Standards (§504)
Stairway Handrails Requirements in the ADA Standards (§504) Protruding Objects The ADA Standards address hazards posed by protruding objects, such as standpipe...
-
B. Major Provisions
The rule also specifies that movie theaters that convert from analog projection systems to digital cinema projection systems after the publication date of the rule in the Federal Register...