abilities of power chair users represented as the percentage of users expected to reach to a target location in the forward reach direction for a given (a) height from the floor (shown the vertical...
Search Results "Vertical Platform Lift"
-
Locating Controls & Devices: Percent of People Who Can Reach the Matrix Cell Indicated While Holding No Weight - Forward Approach Power Chair
-
Landings [§405.7]
Handrails, edge protection, vertical posts and other elements cannot obstruct or overlap the minimum 60” by 60” clearance....
-
11B-703.7.2.6.3 Unisex toilet and bathing facilities
The vertices of the triangle shall be located ¼ inch (6.4 mm) maximum from the edge of the circle....
-
5. Is a talk tube where two children talk to each other simultaneously considered one or two play components? If one end of the talk tube is at ground level and the other is on an elevated deck, is it considered a ground level or elevated play component?
A talk tube with one end located at ground level and another on an elevated deck or platform would be considered an elevated play component....
-
Accessible Routes
An accessible route is not required to serve raised diving boards, platforms, or water slides....
-
12162(e)(2)(A)(ii)(II) Commuter rail
after July 26, 1990, except that the time limit may be extended by the Secretary of Transportation up to 20 years after July 26, 1990, in a case where the raising of the entire passenger platform...
- Solidwave High Low Baby Changer
-
604.4 Seats
Seats shall not be sprung to return to a lifted position. EXCEPTIONS: 1....
-
604.4 Seats
Seats shall not be sprung to return to a lifted position. EXCEPTIONS: 1....
-
604.4 Seats
Seats shall not be sprung to return to a lifted position. EXCEPTIONS: 1....
-
604.4 Seats
Seats shall not be sprung to return to a lifted position. EXCEPTIONS: 1....
-
Is front-in only or angled parking prohibited for accessible parking spaces?
However, where van spaces are angled, the Standards require the access aisle to be located on the passenger side which is the side where vehicle ramps and lifts are typically deployed....
-
§ 38.83(a)(1) General
., lift, ramp or bridge plate) complying with either paragraph (b) or (c) of this section and sufficient clearances to permit at least two wheelchair or mobility aid users to reach areas...
-
Department of Transportation Disability Law Guidance: Use of "Segways" on Transportation Vehicles
However, §37.165(g) requires transit providers to “permit individuals with disabilities who do not use wheelchairs” to use a vehicle’s lift or ramp to enter the vehicle. ...
- Pressalit Care VALUE Support Arm Fixed Height Swing Grab Bar with Leg
-
Element-by-Element Safe Harbor
For example, a hotel must determine whether it is readily achievable to make its swimming pool accessible to people with mobility disabilities by installing a lift or a ramp as specified...
-
Limited-Use/Limited-Application Elevators, Destination-Oriented Elevators and Private Residence Elevators
LULA elevators are also permitted in the 1991 Standards and the 2010 Standards as an alternative to platform lifts....
-
233.1 General
example: Section 206.5.4 requires all doors and doorways providing user passage in residential dwelling units providing mobility features to comply with Section 404; Section 206.7.6 permits platform...
-
11B-608.7 Thresholds
In transfer type shower compartments, thresholds ½ inch (13 mm) high maximum shall be beveled, rounded, or vertical. Exception: Reserved....
-
Companion Seats
This solution should prevent any vertical discrepancies that are not the direct result of differences in the sizes and configurations of wheelchairs....
-
11B-405.9 Edge protection
Edge protection shall not be required on the sides of ramp landings having a vertical drop-off of ½ inch (12.7 mm) maximum within 10 inches (254 mm) horizontally of the minimum landing area...
-
Issue 9: Reach (how far?)
APS should be within the reach range (1.2 m/48 inches vertically, .25m/10 inches horizontally) for an individual who uses a wheelchair (draft PROWAG, R404)....
-
M305.3.2 Height (Section-by-Section Analysis)
For vertical supports, the MDE NPRM proposed that the bottom end of the support be 34 inches high minimum and 37 inches high maximum above the standing surface....
-
Measuring Surface Firmness and Stability
To measure firmness, the precision spring applies force to the penetrator and the caliper measures the vertical displacement of the penetrator into the surface....