The class action settlement ("Settlement Agreement"), which must be approved by the United States District Court, was reached in the case entitled Willits v....
Search Results "Unit of Measurement"
-
NOTICE OF CLASS ACTION
-
Aquatic Access ADA-Compliant LIfts
Aquatic Access offers a variety of portable and stationary lift products that meet all of the 2010 Standards for Accessible Design legally required for public pools in the United States....
-
§382.3 Department or DOT
Department or DOT means the United States Department of Transportation....
-
OTHER PROVISIONS
However, the United States may review Genesis's compliance with this Agreement or title III of the ADA at any time. ...
-
11B-805 Medical care and long-term care facilities
These units must also comply with US Access Board Section 508 Standards for Electronic and Information Technology....
-
11B-217.2 Wheelchair accessible telephones
NUMBER OF TELEPHONES PROVIDED ON A FLOOR, LEVEL, OR EXTERIOR SITE MINIMUM NUMBER OF REQUIRED WHEELCHAIR ACCESSIBLE TELEPHONES 1 or more single units...
-
4.1.2(16)
Telephones, and the following table: Number of public telephones provided on each floor: Number of telephones required to be accessible:* 1 or more single unit...
-
APPENDIX C SUMMARY OF SETTLEMENT AGREEMENT
APPENDIX C SUMMARY OF SETTLEMENT AGREEMENT On [DATE], the United States Department of Justice and Union Parish Detention Center (UPDC) entered into a settlement agreement resolving...
-
11B-217.2 Wheelchair accessible telephones
At least 50 percent of telephone units, but not less than 1 per floor, level, and exterior site [2010 ADAS] 1 per floor, level, and exterior site 1 bank...
-
Access-Able Designs Shower Transfer Bench SH-420-2SDL
Measures 32" W x 16" D Complies w/ ADA 4.21.3 when properly installed 5 year warranty. ...
-
Doorbell Factory Small Rectangle Stainless Steel Doorbell
Solid 3/16" thick Stainless Steel Plate Comes with non-lighted stainless steel push button and mounting screws Measures 1" W X 3" H Usually ships in 1-3 business...
-
Boolee Voting Booth
Materials: 1” Aluminum Frame Table is ABS sheet All fasteners are zinc plated All side panel fabric is 300 x 300 urethane-coated polyester Design Specifications All weights and measures...
-
11B-201.4 Construction Support Facilities
When toilet and bathing facilities serving construction support facilities are provided by portable units, at least one of each type shall be accessible and connected to the construction...
-
11B-232.2 General holding cells and general housing cells
For example, a shift area serving as a medium-security housing unit might be redesignated for a period of time as a high-security housing unit to meet capacity needs....
-
11B-232.2 General holding cells and general housing cells
For example, a shift area serving as a medium-security housing unit might be redesignated for a period of time as a high-security housing unit to meet capacity needs....
-
11B-201.4 Construction Support Facilities
When toilet and bathing facilities serving construction support facilities are provided by portable units, at least one of each type shall be accessible and connected to the construction...
-
TABLE OF CONTENTS
Passenger Drop-off Locations Accessible Routes Ramps Protruding Objects Building Entrance Lifts and Elevators Tools for Surveys Tools and Documentation Completing Measurements...
-
4.1.4 Clear Floor or Ground Space
At least 48 inches (1220 mm) of clear floor or ground space shall surround the usable sides of a picnic table, measured from the back edge of the benches....
-
11B-608.2.3 Alternate roll-in type shower compartments
Alternate roll-in type shower compartments shall be 36 inches (914 mm) wide and 60 inches (1524 mm) deep minimum clear inside dimensions measured at center points of opposing sides....
-
406.8--Modification to 406 of Appendix D to 36 CFR Part 1191
The detectable warning shall extend the full width of the curb ramp (exclusive of flared sides) and shall extend either the full depth of the curb ramp or 24 inches (610 mm) deep minimum measured...
-
11B-703.2.5 Character height
Character height measured vertically from the baseline of the character shall be 5/8 inch (15.9 mm) minimum and 2 inches (51 mm) maximum based on the height of the uppercase letter “I”....
-
4.15.3 Spout Location
The spouts of drinking fountains and water coolers shall be at the front of the unit and shall direct the water flow in a trajectory that is parallel or nearly parallel to the front of the...
-
Welch Allyn Scale-Tronix® Integrated Scales
You need fast, accurate weight measurement. Your patients need low-profile solutions designed to help reduce their fall risks and support wide-ranging weights....
-
Sears Brands, LLC Craftsman 24 in. Digital LaserTrac® Level
This level recalls the last nine measurements, calculates the degrees between two angles and projects a laser dot accurately to 1/4" at 100 feet....
