Manufacturers usually impress the Braille into a standard metal sign attached to the APS housing....
Search Results "ANSI/IEEE: American National Standards Institute/ Institute of Electrical and Electronics Engineers"
Commonly Searched Documents
-
Issue 10: Braille (right side up?)
-
Reliance on Preamble to Guidelines
The final Guidelines provide builders with a safe harbor that, short of specifying all of the provisions of the ANSI Standard, illustrate acceptable methods of compliance with the Act....
-
1.2.6
The 1980 ANSI A117 standard also allowed this with the additional provision that an existing ramp slope of up to 1:8 could have a maximum run of 2 feet (0.6 m)....
-
Single Occupant Structures: ADA Standard Section 203.6
Section 203.6 covers scoping requirements of general exceptions for single occupant structures in the most current ADA Standards.
- Salsbury Industries Series Triple Tier 1 Wide Standard Metal Lockers
-
BACKGROUND
Specifically, the complaint alleged that patients of the Michigan Institute for Neurological Disorders who have mobility disabilities cannot access their physician's office, located in Suite...
- AFB Breakthroughs 30-Second PSA (Accessible Version)
-
(4) Doors to public and common use areas
The final Guidelines continued to provide that on accessible routes in public and common use areas, and for primary entry doors to covered units, doors that comply with ANSI 4.13 meet the...
-
10. Drinking fountains and water coolers
Accessible element or space ANSI A117.1 section APPLICATION 10....
-
c-ii
Yes No If Yes, and the elevator or lift is part of the accessible route to a shelter area, is back-up electrical power available to operate the elevator or lift for the duration...
-
Wheelchair Space or Transfer Seat or Transfer Device
Sections 234.3 and 1002.4 - 1002.6 of the 2010 Standards provide that each new and altered amusement ride, except for mobile/portable rides and a few additional excepted rides, will be required...
-
General: ADA Standard Section 214.1
Section 214.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for washing machines and clothes dryers.
-
General: ADA Standard Section 303.1
Section 303.1 of the ADA Standards covers information in the current ADA Standards for changes in level for floor and ground surfaces.
-
General: ADA Standard Section 609.1
Section 609.1 of the ADA Standards covers information in the current ADA Standards for grab bars in toilet facilities and bathing facilities.
-
General: ADA Standard Section 213.1
Section 210.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for toilet facilities and bathing facilities.
-
General: ADA Standard Section 220.1
Section 220.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for automatic teller and fare machines.
-
General: ADA Standard Section 222.1
Section 222.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for dressing, fitting, and locker rooms.
-
General: ADA Standard Section 243.1
Section 243.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for shooting facilities and firing positions.
-
General: ADA Standard Section 226.1
Section 226.1 of the ADA Standards covers information in the current ADA Standards on scoping requirements for dining surfaces and work surfaces.
-
ALIGNMENT OF 19-INCH RECOMMENDATION WITH ACCESS BOARD PROPOSED RULEMAKING
under static conditions, without compression or deflection in the transfer surface ….”8 The Access Board’s proposal also explained that it is considering a requirement in the final standards...
-
(2) Transfer Surface Location for Diagnostic Equipment Used in the Seated Position
MDE Advisory Committee Report, 83, available at https://www.access-board.gov/guidelines-and-standards/health-care/about-this-rulemaking/advisory-committee-final-report....
-
III-6.1000 General
ILLUSTRATION 3: An electrical outlet is being relocated....
-
1010.2.13.1 Delayed egress locking system
Once the delay electronics have been deactivated, rearming the delay electronics shall be by manual means only....
-
2.1.1 General Description
This electrical current creates an electromagnetic field around the wire....