In transfer type shower compartments, the controls, faucets, and shower spray unit shall be installed on the side wall opposite the seat 38 inches (965 mm) minimum and 48 inches (1220 mm...
Search Results "Seat Width"
Commonly Searched Documents
-
608.5.1 Transfer Type Shower Compartments
-
608.5.1 Transfer Type Shower Compartments
In transfer type shower compartments, the controls, faucets, and shower spray unit shall be installed on the side wall opposite the seat 38 inches (965 mm) minimum and 48 inches (1220 mm...
-
§ 36.406(d)(2)
(2) Facilities with more than 50 beds covered by this section that provide common use bathing facilities, shall provide at least one roll in shower with a seat that complies with the relevant...
-
§ 38.29(e)
For vehicles in excess of 22 feet in length with front-door lifts or ramps, vertical stanchions immediately behind the driver shall either terminate at the lower edge of the aisle-facing seats...
-
11B-903.6 Structural strength
Allowable stresses shall not be exceeded for materials used when a vertical or horizontal force of 250 pounds (1112 N) is applied at any point on the seat, fastener, mounting device, or...
- CRL Jackson 900 Series Floor Mounted Door Closers
-
810.9 Escalators
Where provided, escalators shall comply with the sections 6.1.3.5.6 and 6.1.3.6.5 of ASME A17.1 (incorporated by reference, see "Referenced Standards" in Chapter 1) and shall have a clear width...
-
Kickplates
If provided, it is recommended that they cover almost the full door width up to a height of 16 inches from the bottom edge....
-
§ 38.125(c)(2) Ramp surface
The ramp or bridge plate surface shall be continuous and slip resistant, shall not have protrusions from the surface greater than 1/4 inch high, shall have a clear width of 30 inches and...
-
4.4 Knee and Toe Clearances
620-640 X 500-650 Reduction Angle 1:6 X X X Width...
-
§382.111(a)
(a) Assistance in moving to and from seats, as part of the enplaning and deplaning processes;...
-
§ 36.406(f)(4)(i)
(i) It is located within the rear 60% of the seats provided in an auditorium; or...
-
§ 35.151(g)(4)(i)
(i) It is located within the rear 60% of the seats provided in an auditorium; or...
- Boolee Multi-Station Voting Booth
-
11B-502.6.3 Location
Signs shall be permanently posted either immediately adjacent to the parking space or within the projected parking space width at the head end of the parking space....
-
810.2.2 Dimensions
Bus stop boarding and alighting areas shall provide a clear length of 96 inches (2440 mm) minimum, measured perpendicular to the curb or vehicle roadway edge, and a clear width of 60 inches...
-
11B-307.4.1 Guy braces
Where a guy support is used within either the width of a circulation path or 24 inches maximum outside of a circulation path, a vertical guy brace, sidewalk guy or similar device shall be...
-
Ramps
For each elevated ramp run: 12-inch (305 mm) maximum rise 1:12 maximum slope 36-inch (915 mm) minimum clear width ...
-
404.2.4 Maneuvering Clearances
Maneuvering clearances shall extend the full width of the doorway and the required latch side or hinge side clearance....
-
11B-502.6.3 Location
Signs shall be permanently posted either immediately adjacent to the parking space or within the projected parking space width at the head end of the parking space....
-
11B-502.6.3 Location
Signs shall be permanently posted either immediately adjacent to the parking space or within the projected parking space width at the head end of the parking space....
- AbilityApp
-
§382.113(b)
(b) Assistance within the restroom or assistance at the passenger's seat with elimination functions; and...
-
§382.27(c)(4)
(4) Transportation for an electric wheelchair on an aircraft with fewer than 60 seats;...