The identification fixture shall be 80 inches (2032 mm) minimum above the finish floor or ground to the bottom of the fixture....
Search Results "Input Floor"
Commonly Searched Documents
-
11B-411.2.2.1 Visible identification
-
7.3 Imaging System Accessibility Configuration Examples and Concerns
(or raising the room floor)....
- Disability in Action - Abilene, TX
- Disability Connections - San Angelo, TX
- Tile Tech Pavers® Porcelain Pavers™ Series
- Wilkinson Hi-Rise Trash Chute
-
Feminine product dispensers
For purposes of resolving this matter, the Museum will provide, on each floor, at least one feminine product dispenser in the women's toilet rooms that does not requires tight grasping and...
-
803.5 Coat Hooks and Shelves
Shelves shall be 40 inches (1015 mm) minimum and 48 inches (1220 mm) maximum above the finish floor or ground....
-
1i
Are all of the small showers free of curbs or lips greater than 1/2" high at the shower floor that would impede wheelchair approach and transfer onto the folding shower seat?...
-
Volume Controls
Do at least 25% (not less than one) of all other house phones on each floor have volume controls? Yes __ No __ N/A __ Comments: ___________________________________________...
-
Volume Controls
Do at least 25% (not less than one) of all other pay phones on each floor have volume controls? Yes __ No __ N/A __ Comments: ___________________________________________...
-
Volume Controls
Do at least 25% (not less than one) of all other pay phones on each floor have volume controls? Yes __ No __ N/A __ Comments: ___________________________________________...
-
§ 38.31(b)
doorways in which lifts or ramps are installed, shall have, at all times, at least 2 foot-candles of illumination measured on the step tread, or lift or ramp, when deployed at the vehicle floor...
-
11B-809.8.4 Door signal devices
The activating mechanism shall be mounted 48 inches (1219 mm) maximum above the floor and connected to permanent wiring....
-
11B-502.6 Identification
Signs shall be 60 inches (1524 mm) minimum above the finish floor or ground surface measured to the bottom of the sign. [2010 ADAS] 502.6 Identification. ...
-
Alterations [4.1.6(1)(f) & (k)]
Thus, the exception from the requirement for an elevator in buildings with less than 3 stories or with less than 3,000 square feet per floor applies to altered facilities as well, including...
-
Trail Facilities
For example, if a camp shelter is provided along a trail and its floor is above the ground, all hikers must be able to get inside the shelter....
-
11B-502.6 Identification
Signs shall be 60 inches (1524 mm) minimum above the finish floor or ground surface measured to the bottom of the sign. [2010 ADAS] 502.6 Identification. ...
-
SHOPPING CENTER (OR SHOPPING MALL)
A shopping center may include a series of buildings on a common site, connected by a common pedestrian access route on, above or below the ground floor, that is either under common ownership...
-
11B-502.6 Identification
Signs shall be 60 inches (1524 mm) minimum above the finish floor or ground surface measured to the bottom of the sign. [2010 ADA Standards] 502.6 Identification....
-
Designations: ADA Standard Section 216.2
Section 216.2 covers scoping requirements in the current ADA Standards for sign designations.
-
Path of Travel
(2) An accessible path of travel may consist of walks and sidewalks, curb ramps and other interior or exterior pedestrian ramps; clear floor paths through lobbies, corridors, rooms,...
-
Protrusion Limits: ADA Standard Section 307.2
Section 307.2 covers the current ADA Standards for protrusion limits.