LL94 - Door Lever Finish: PSS SSS Material: Marine Grade (316) Stainless Steel *Privacy Type: Using push pin on rose *Privacy Type: Using mortise bolt and turn piece...
Search Results "Clear Width at Turn"
Commonly Searched Documents
- Linnea Lever LL94
- Linnea Lever LL100
- Linnea Lever LL148
- Linnea Lever LL77
- Linnea Lever LL92
- Linnea Lever LL136
- Linnea Lever LL26
- Linnea Lever LL63
-
DETR
Width was the unoccupied width. Height was taken from the ground to the highest point, either chair or person....
- American Safety Tread Co., Inc. Type G4702 Stairway Nosing Replacement
-
Q3: Roadway Resurfacing Alteration Project and Curb Ramp Improvements
Q3: If a roadway resurfacing alteration project does not span the full width of the road, do I have to put in curb ramps?...
-
Tread Obstacles [1017.5]
Frequent tread obstacles and tread obstacles that cross the full width of a trail tread can make travel very difficult for people using mobility devices....
-
Alterations: Alternate Stalls
Alternate designs in ADAAG Figure 30(b) allow narrower stall widths while requiring greater depth....
-
Outdoor Rinsing Showers
Locate the clear space so that the shower pedestal or wall to which the showerhead is attached is at the center back of the clear space so that the water from the showerhead is directed...
-
M301.2.3.1 End Transfer Surface
EXCEPTION: Transfer surfaces for imaging equipment with bores shall be permitted to be 21 inches (535 mm) wide minimum but shall not be permitted to be less than the full width of the examination...
-
M301.2.3.2 Side Transfer Surface
EXCEPTION: Transfer surfaces for imaging equipment with bores shall be permitted to be 21 inches (535 mm) wide minimum but shall not be permitted to be less than the full width of the examination...
-
404.2.4 Maneuvering Clearances
Maneuvering clearances shall extend the full width of the doorway and the required latch side or hinge side clearance....
-
C. M303 Diagnostic Equipment Used by Patients Seated in a Wheelchair
significant changes to accommodate the unique challenges of mammography equipment; one significant change to the ramped running slope requirement; and a final significant change to the width...
-
Transfer Steps
Each transfer step must have a tread depth of 14 inches minimum to 17 inches maximum and a minimum tread width of 24 inches....
-
Transfer Surface Size – M301.2.2 Supine, Prone, or Side-Lying Position
Transfer Surface Size – M301.2.2 Supine, Prone, or Side-Lying Position The issues were discussed and decided in the full committee meeting as follows: depth of 17 inches minimum and width...
-
M7
If the door swings into the room, does the door swing not overlap the required clear floor space for the toilet or lavatory?...
-
4. Exception from the Requirements of M301 for Certain Examination Chairs that Comply with M302
The Access Board sought public input in question three in the preamble in the MDE NPRM, on whether organizing the technical criteria functionally by patient position was clear. 77 FR at...
-
Trailhead Information Signs [F216.13 and 1017.10]
new trail information signs must include the following information: Length of the trail or trail segment Type of trail surface Typical and minimum trail tread width...
-
Getting From Here to There—Outdoor Recreation Access Routes
Design outdoor recreation access routes to meet technical requirements for running and cross slopes, resting intervals, surface, clear tread width, passing spaces, tread obstacles, protruding...