Buttons shall have square shoulders, be ¾ inch (19.1 mm) minimum in their smallest dimension and be raised 1/8 inch (3.2 mm) plus or minus 1/32 inch (0.8 mm) above the surrounding surface...
Search Results "Check Writing Surface"
Filters
Commonly Searched Documents
-
11B-407.4.6.2.1 Size and shape
-
11B-704.5 TTY shelf
The telephone handset shall be capable of being placed flush on the surface of the shelf....
-
National Eye Health Education Program (NEHEP) Vision and Aging: Resources
Be sure to also check out the rest of our educational resources. Resources include: Educational Resources Articles Fact sheets Handouts Infocards Infographics...
-
Conclusions
Conclusions The proposed guidelines for medical diagnostic equipment currently recommend a minimum transfer surface 30 in. (760mm) wide and 15 in. (381mm) deep....
-
§ 382.33 Advance notice requirements
(b) A carrier may require up to 48 hours advance notice and one-hour advance check-in concerning a qualified individual with a disability who wishes to receive any of the following services...
-
5.9 Standing Support Recommendations for M304 Diagnostic Equipment Used by Patients in a Standing Position
The proposed provision requires standing supports be provided on each side of the standing surface....
-
R305.1.3 Contrast
Detectable warning surfaces shall contrast visually with adjacent gutter, street or highway, or pedestrian access route surface, either light-on-dark or dark-on-light....
-
IV. Eligibility for Goods and Services
Requirements that tend to screen out individuals with disabilities, such as requiring a blind person to produce a driver's license as the sole means of identification for cashing a check...
-
"Place of Lodging" (Section-by-Section Analysis)
conditions and amenities of a hotel include rooms available on a walk-up basis, linen service, and accepting reservations for a room type without guaranteeing a particular unit or room until check-in...
-
Temporary Solutions For Emergency Sheltering - Ramps
Suggestion: Check to see if there is another accessible route to the accessible entrance. Sometimes there is a less direct route that is accessible....
-
Are carriers required to provide wheelchair service from the curb to the airplane or only from the ticket counter to the airplane?
If requested, after your flight arrives at your destination, the carrier must also assist you in claiming your checked luggage before assisting you in a wheelchair to the curb....
-
Verify Framing
Check plans for Fire Assembly thickness 11B-407.4 Location of controls for operable windows to meet reach range and operation 11B-229 Restroom dimensions....
-
Verify Framing
Check plans for Fire Assembly thickness 11B-407.4 Location of controls for operable windows to meet reach range and operation 11B-229 Restroom dimensions....
-
REFERENCES
Please check the DSA website for currently effective IRs....
-
GUARD [DSA-AC, HCD 1, HCD 2 & HCD 1-AC] OR GUARDRAIL
A building component or a system of building components located at or near the open sides of elevated walking surfaces that minimizes the possibility of a fall from the walking surface to...
-
407.3.1 Identification (Section-by-Section Analysis)
It also would require key surfaces outside active areas of display screens to be raised above their surrounding surfaces....
-
1008.3.1.2 Height
The height of transfer platforms shall be 11 inches (280 mm) minimum and 18 inches (455 mm) maximum measured to the top of the surface from the ground or floor surface....
-
1008.3.1.2 Height
The height of transfer platforms shall be 11 inches (280 mm) minimum and 18 inches (455 mm) maximum measured to the top of the surface from the ground or floor surface....
-
R405.2.1 General
Space under an element between the finish surface and 230 mm (9 in) above the finish surface shall be considered toe clearance and shall comply with R405.2....
-
1008.2.5.3.2 Handrail Height
The top of handrail gripping surfaces shall be 20 inches (510 mm) minimum and 28 inches (710 mm) maximum above the ramp surface....
-
11B-1008.3.1.2 Height
The height of transfer platforms shall be 11 inches (279 mm) minimum and 18 inches (457 mm) maximum measured to the top of the surface from the ground or floor surface....
-
11B-1008.3.1.2 Height
The height of transfer platforms shall be 11 inches (279 mm) minimum and 18 inches (457 mm) maximum measured to the top of the surface from the ground or floor surface....
-
11B-1008.3.1.2 Height
The height of transfer platforms shall be 11 inches (279 mm) minimum and 18 inches (457 mm) maximum measured to the top of the surface from the ground or floor surface....
-
PHYSICAL CHANGES TO FACILITIES
by the language of Attachments H, I, and J are reasonably anticipated to become moot before the expiration of the deadlines associated with those modifications, the City may request in writing...
