The Impact of Transfer Setup on the Performance of Independent Transfers: Final Report REPORT PREPARED FOR: U.S. ACCESS BOARD, WASHINGTON, DC Authors: Alicia Koontz, PhD,...
Search Results "Extended Floor Surface"
-
The Impact of Transfer Setup on the Performance of Independent Transfers: Phase I Final Report
-
Tactile Surface
The proposed rule included provisions that generally recognized alternative tactile surfaces equally detectable underfoot or other designs or technologies that provide equal or superior...
- TotTurf® Synthetic Grass: Play Spaces
-
11B-233.3.1.2.5 Public housing facility site impracticality
The remaining ground floor residential dwelling units shall comply with the following requirements: 1. Grab bar reinforcement complying with Section 11B-609. 2. ...
-
Accessibility Requirements for Occasional Public Use on Second Floor of Older Office Buildings
I have a question about older two-story office buildings that were built before the ADA and do not have an accessible route to the second floor....
- Access Board: Single User Toilet Room Size and Layout
-
20. Q: What about holding cells and jails that are not accessible?
A: An arrestee with a mobility disability must have access to the toilet facilities and other amenities provided at the lock-up or jail. A law enforcement agency must make structural...
-
22. Q. We are building a new prison. Do we need to make it accessible?
A: Yes. All new buildings must be made fully accessible to, and usable by, individuals with disabilities. The ADA provides architectural standards that specify what must be done to...
-
11B-603.2.3 Door swing
SECTION TITLE NOTES 11B-603.2.3 Door swing. Clarifies that doors to accessible toilet compartments are...
-
B. M301 Diagnostic Equipment Used by Patients in a Supine, Prone, or Side-lying Position and M302 Diagnostic Equipment Used by Patients in a Seated Position
Therefore, the Significant Changes Section addresses the transfer surface and lift compatibility requirements for M301 and M302 together....
-
4.32.4* HEIGHT OF WORK SURFACES
The tops of tables and work surfaces shall be from 28 in to 34 in (710 mm to 865 mm) from the floor or ground....
- Magnuson Group RIGA Series Waste Receptacle
-
M305.2.3 Height
During use, the tops of transfer support gripping surfaces shall be 6 inches (150 mm) minimum and 19 inches (485 mm) maximum higher than the top of the associated uncompressed transfer surface...
-
11B-405.9.2 Curb or barrier
A curb or barrier shall be provided that prevents the passage of a 4-inch (102 mm) diameter sphere, where any portion of the sphere is within 4 inches (102 mm) of the finish floor or ground...
-
11B-405.9.2 Curb or barrier
A curb or barrier shall be provided that prevents the passage of a 4-inch (102 mm) diameter sphere, where any portion of the sphere is within 4 inches (102 mm) of the finish floor or ground...
- Willoughby Industries ASETW1490FM Ligature-Resistant Floor Mounted Blowout Series Water Closet
-
Plan 3A: 12-Foot Wide Accessible Guest Room
the bathroom: • Comparable vanity counter top space (section 806); • Bathtub (section 607.2); • Removable bathtub seat (section 607.3); • Clearance in front of the bathtub extends...
-
Plan 1A: 13-Foot Wide Accessible Guest Room
vanity counter top space (section 806); • Bathtub with a lavatory at the control end (section 607.2); • Removable bathtub seat (section 607.3); • Clearance in front of the bathtub extends...
-
Plan 1B: 13-Foot Wide Accessible Guest Room
vanity counter top space (section 806); • Bathtub with a lavatory at the control end (section 607.2); • Removable bathtub seat (section 607.3); • Clearance in front of the bathtub extends...
-
11B-812.9 Surface marking
EVCS vehicle spaces shall provide surface marking stating “EV CHARGING ONLY” in letters 12 inches (305 mm) high minimum....
-
11B-812.9 Surface marking
EVCS vehicle spaces shall provide surface marking stating “EV CHARGING ONLY” in letters 12 inches (305 mm) high minimum....
-
Clear Ground Space [1011.2]
The technical requirements include specific provisions for the size, location, surface, slope, and openings in the clear ground space....
-
5.4.1 Transfer Support Location for M301 and M302
Provisions require transfer supports be provided for use with the transfer sides and be located within reach of the transfer surface and not obstruct transfer onto the surface when in position...