verification of a product's compliance with specified accessibility standards, codes, and normative documents....
Search Results "Electroacoustic Performance Standards"
Filters
Commonly Searched Documents
-
Accessible Product Certification Process
-
Transfer Sides (M301.2.3 and M302.2.3)
approach parallel to the deep dimension of the transfer surface, parallel to the wide dimension of the transfer surface, or at an angle to the corner of the transfer surface and be able to perform...
-
Study Limitations
When performing these transfers to a higher elevation participants could be transferring to a seat around 31.5 inches off the ground....
-
Section 35.150(b)(2) Safe Harbor (Section-by-Section Analysis)
, required to modify those elements in order to reflect incremental changes in the proposed standards. ...
-
II-6.5000 Alterations to historic properties
Under those provisions, alterations should be done in full compliance with the alterations standards for other types of buildings....
-
SERVICE ANIMALS
Service animals are defined as dogs that are individually trained to do work or perform tasks for a person with a disability....
-
M101.5 Dimensions
The MDE Standards are based on adult dimensions and anthropometrics. Dimensions that are not stated as “maximum” or “minimum” are absolute....
-
407.4.6.3 Keypads
Car control keypads shall be in a standard telephone keypad arrangement and shall comply with 407.4.7.2....
-
i.
"Suspicious Minds" Exhibit ramp leading to the exhibits; and See Standards § 4.8.5(3)....
-
407.4.6.3 Keypads
Car control keypads shall be in a standard telephone keypad arrangement and shall comply with 407.4.7.2....
-
E202.1 General
ICT shall be exempt from compliance with the Revised 508 Standards to the extent specified by E202....
-
E202.4 Federal Contracts
ICT acquired by a contractor incidental to a contract shall not be required to conform to the Revised 508 Standards....
-
E201.1 Scope
ICT that is procured, developed, maintained, or used by agencies shall conform to the Revised 508 Standards....
-
225(d)(1)(B)
(B) establish minimum standards that shall be met in carrying out subsection (c) of this section;...
-
Station platforms
(DOT ADA Standard 810.5.3.)...
-
M18
[ADA Standards § 4.16.5] Yes No...
-
11B-705.1.1.3.1
Detectable warning surfaces shall be yellow and approximate FS 33538 of Federal Standard 595C....
-
§40.3(b)(3)
(3) The alteration of an existing building, or of such portions thereof, to which application of the standards is not structurally feasible....
-
ADMINISTRATIVE AUTHORITY
A governmental agency that adopts or enforces regulations and standards for the design, construction, or alteration of buildings and facilities....
-
§100.201a(b)
(b) The addresses of organizations from which the referenced standards can be obtained appear below:...
-
Accessible Routes to Press Boxes
The 1991 Standards, at sections 4.1.1(1) and 4.1.3(1), cover all areas of newly constructed facilities required to be accessible, and require an accessible route to connect accessible entrances...
-
G. What are Detectable Warnings, Why are They Required, and Where Must They be Provided?
The ADA Standards require that curb ramps include features called “detectable warnings.”...
-
Alterations to Primary Function Areas
202.4 restates a current requirement under title III, and therefore represents no change for title III facilities or for those title II facilities that have elected to comply with the 1991 Standards...
-
M101.3 Existing Diagnostic Equipment (Section-by-Section Analysis)
The MDE NPRM did not address when or how the MDE Standards would be applied to existing medical diagnostic equipment....