The lift platform (not including the entrance ramp) shall not deflect more than 3 degrees (exclusive of car roll) in any direction between its unloaded position and its position when loaded...
Search Results "Curb Ramp Top Landing"
Commonly Searched Documents
-
ยง 38.125(b)(9) Platform deflection
-
Background
In Phase I, processing techniques and material properties were evaluated in small bench-top and full-depth laboratory tests (Laufenberg and others 2003)....
-
1007.3 Enclosed exit stairways
of an accessible means of egress, shall have a clear width of 48 inches (1219 mm) minimum between handrails and shall either incorporate an area of refuge within an enlarged floor-level landing...
-
2.1 Participantsโ Vision
Forty-two of the participants had visual acuities of 20/200 or less, including nine participants who were unable to read the top line (largest letter) of the acuity chart, indicating that...
- Smith System Lift Desk Work Surface with Crank
-
Door and Gate Hardware
locks at existing glazed doors without stiles, existing overhead rolling doors or grilles, and similar existing doors or grilles that are designed with locks that are activated only at the top...
-
11B-703.2.7 Character spacing
minimum and 4 times the raised character stroke width maximum at the base of the cross sections, and 1/8 inch (3.2 mm) minimum and 4 times the raised character stroke width maximum at the top...
-
Accessible Routes to Press Boxes
Some are located at the top of bleachers. As a result, their design and location have posed unique challenges to the provision of a connecting accessible route....
-
610.3 Shower Compartment Seats
The top of the seat shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the bathroom finish floor. Seats shall comply with 610.3.1 or 610.3.2....
-
Accessible Routes
There are two types of accessible routes: Ground-level Elevated This ground-level route (above, top) connects ground components and the transfer system which...
-
Transfer Supports Location and Configuration M301.3 and M302.3
Transfer Supports Location and Configuration M301.3 and M302.3 Location of the transfer supports shall be a minimum of 6 inches to a maximum of 19 inches from the top of the transfer...
-
604.7 Dispensers
If toilet paper dispensers are installed above the side wall grab bar, the outlet of the toilet paper dispenser must be 48 inches (1220 mm) maximum above the finish floor and the top of...
-
610.3 Shower Compartment Seats
The top of the seat shall be 17 inches (430 mm) minimum and 19 inches (485 mm) maximum above the bathroom finish floor. Seats shall comply with 610.3.1 or 610.3.2. ย ย ...
-
Publicizing the ADA: Advocacy and the Government Response
They planned to use the politics of an election year as a way to publicize the ADA and gain a foothold as a top priority for the next session of Congress....
- Harmar RPL Residential Vertical Platform Lift
- Harmar EPL Enclosed Vertical Platform Lift
- Signaids App to Use with Signaids Signs
- GameTime Rock N Raft Play Component
-
ยง 38.159(a)(1) General
., lift or ramp) complying with paragraph (b) or (c) of this section and sufficient clearances to permit a wheelchair or other mobility aid user to reach a securement location....
- SOTARE Waste Receptacles
-
b) Accessibility
Mary's Playground, Kirola's inspection team recorded the maximum localized variation as the overall slope of the curb ramp rather than the curb ramp's overall "rise in run" and flatness,...
-
11B-205.1 General
Where two or more outlets are provided in a kitchen above a length of counter top that is uninterrupted by a sink or appliance, one outlet shall not be required to comply with 309....
-
4.3.5.3 180-degree turn around an obstacle
4.3.5.3 180-degree turn around an obstacle This type of turn is applicable to turning at a landing where one is reversing direction to move back along a parallel path, e.g. at the end...
- USDA Forest Service Built Environment Image Guide (BEIG)