Car and van parking spaces shall comply with Section 11B-502....
Search Results "Car Ramp"
Commonly Searched Documents
-
11B-502.1 General
-
1.2.2
1.2.2 When flatness of running slope for an accessible surface other than a ramp is measured according to Section 1.1.5 no more than 20% (rounded to the nearest whole number) of the measurements...
-
11B-303.3 Beveled
Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). ...
- Don’t tell me I can’t: disability in a modern world | Cheryl Stowe | TEDxFurmanU
-
6b.
Is the change in level from the floor to the lift surface ramped or beveled? Yes _____ No _____...
-
ACTIONS TAKEN BY CITY OF WAUKEGAN
The City installed an interior ramp that was meant to provide access from the old city hall to the new city hall addition. ...
-
Construction Specification Institute
Construction Specification Institute While developing suggested tolerances for surface materials, the Construction Specifications Institute developed a suggested method for measuring ramp...
-
11B-108 Maintenance of accessible features
It is not sufficient to provide features such as accessible routes, parking, elevators, ramps or signage if those features are not maintained in a manner that enables individuals with disabilities...
- Walk-A-Sured Roll-On Anti-Slip Safety Coating System
- Walk-A-Sured Clear Anti-Slip Safety Coating System
-
i.
"Suspicious Minds" Exhibit ramp leading to the exhibits; and See Standards § 4.8.5(3)....
-
T402.4 Emergency Operation
Power-operated ramps and bridgeplates shall be capable of manual operation in the event of a power failure....
-
§ 37.91(e)
(e) On any train in which either a single level or bi-level dining car is used to provide food service, a person providing intercity rail service shall provide appropriate aids and services...
- Inclusion Solutions BigBell™ Alert System
-
Homemods.org
., grab bars, ramps), moving furnishings, changing where activities occur (e.g., sleeping on the first instead of second floor) and renovations (e.g., installing a roll-in shower)....
-
R305 Detectable Warning Surfaces (Section-by-Section Analysis)
At curb ramps and blended transitions, detectable warning surfaces must extend the full width of the ramp run (excluding flared sides), blended transition, or turning space....
-
1. Typical Issues for Individuals Who Use Wheelchairs, Scooters, or Other Mobility Devices
Where ramps are used, they cannot be steeper than 1:12. Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
Part 1. Typical Issues for Voters Who Use Wheelchairs, Scooters, or Other Mobility Devices
Where ramps are used, they cannot be steeper than 1:12. Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
If a passenger loading area serves cars and vans, as well as buses, must the provisions for passenger loading zones and bus loading zones both be satisfied?
No, provisions for bus loading zones (§810.2) apply only to on-street bus stops and those bus loading zones that exclusively serve designated or specified public transportation...
-
303.3 Beveled
Changes in level exceeding ½ inch (13 mm) must comply with 405 (Ramps) or 406 (Curb Ramps). Figure 303.3 Beveled Change in Level ...
-
Comments from Individuals Who Are Blind or Have Low Vision (Section-by-Section Analysis)
Blind was a member of the advisory committee that recommended the proposed guidelines, but filed a minority report recommending detectable warning surfaces should be required only on curb ramps...
-
R302.6 Cross Slope
Cross slope requirements are contained in R304.5.3 for curb ramps and blended transitions, and in R407.3 for ramps....
-
Slope [4.3.7]
Where the running slope of an accessible route exceeds 5% it must be treated as a ramp or curb ramp. A maximum cross slope of 2% is recognized for drainage....
-
11B-405.9.2 Curb or barrier
To prevent wheel entrapment, the curb or barrier shall provide a continuous and uninterrupted barrier along the length of the ramp....