that at least two flat steps be provided at the entrance and exit of every escalator and that steps on escalators be demarcated by yellow lines 2 inches wide maximum along the back and sides...
Search Results "Latch Side Clearance"
Commonly Searched Documents
-
ASME
-
Aisle Seats
The proposed rule required that such seats have removable or folding armrests or no armrests on the aisle side....
-
1007.7.4 Separation
The fire-resistance-rated exterior wall construction shall extend horizontally 10 feet (3048 mm) beyond the landing on either side of the landing or equivalent fire-resistance-rated construction...
-
Water Closet Location and Rear Grab Bar
The 1991 Standards contain no exception for grab bar length, and require the water closet centerline to be exactly 18 inches from the side wall, while the 2010 Standards requirement allows...
-
308.1 General
These dimensions apply to either forward or side reaches....
-
610.3 Shower Compartment Seats
Where a seat is provided in a standard roll-in shower compartment, it shall be a folding type, shall be installed on the side wall adjacent to the controls, and shall extend from the back...
-
308.1 General
These dimensions apply to either forward or side reaches....
-
Temporary Solutions For Emergency Sheltering - Protruding Object Hazards
Temporary Solutions For Emergency Sheltering - Protruding Object Hazards Problem: Objects protrude too far from the side into the route causing a hazard for people who are blind or who...
-
308.1 General
These dimensions apply to either forward or side reaches....
-
11B-308.1 General
These dimensions apply to either forward or side reaches....
-
Hand Cycles (Stand-Alone)
Additional support, as required, is provided by small caster wheels that are mounted on each side just behind the seat....
-
11B-308.1 General
These dimensions apply to either forward or side reaches....
-
11B-308.1 General
These dimensions apply to either forward or side reaches....
- Yale 1100 Series Industrial Door Closer
- Yale 2700 Series Architectural Door Closer
- Cal-Royal Legacy Series Locksets
- Direct Access Solutions Kit
- BEST Door Lever Hardware Cylindrical Locks - 7KC
-
1015.3 Height
Exceptions: For occupancies in Group R-3, and within individual dwelling units in occupancies in Group R-2, guards on the open sides of stairs shall have a height not less than 34...
-
11B-604.8.1.1 Size
Wheelchair accessible compartments shall be 60 inches (1524 mm) wide minimum measured perpendicular to the side wall, and 56 inches (1422 mm) deep minimum for wall hung water closets and...
-
K4
, drink, condiment, and tableware dispensers are provided, are dispensers and operating controls mounted no higher than 54 inches above the floor if clear floor space is provided for a side...
-
Jamb Signage
...are all elevator jambs provided with signs placed on both sides designating the floor with 2" minimum height raised letters and Braille characters centered at 60" above the finish floor...
-
I1a
For a side approach (clear floor space at least 30 inches long x 48 inches wide), is the coin slot no higher than 54 inches above the floor?...
-
5e.
Are signs mounted on both sides of the elevator hoistway door opening that designate the floor with 2-inch minimum-height raised letters and Braille characters centered at 60 inches above...