Swinging door and gate surfaces within 10 inches (255 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
Search Results "Pull Side"
Filters
Commonly Searched Documents
-
404.2.10 Door and Gate Surfaces
-
505.6 Gripping Surface
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
5.8.1 Wheelchair Spaces on Raised Platforms Recommendations
Where wheelchair spaces can be entered only from the side, the wheelchair space shall be 60 inches deep minimum....
-
711.3.2 Membrane penetrations
Outlet boxes on opposite sides of the wall shall be separated as follows: 1.1. By a horizontal distance of not less than 24 inches (610 mm); 1.2....
-
Requirement 5. Light switches, electrical outlets, thermostats and other environmental controls in accessible locations.
the reach is over an obstruction (for example, an overhanging shelf) between 20 and 25 inches in depth, the maximum height is reduced to 44 inches for forward approach; or 46 inches for side...
-
404.2.10 Door and Gate Surfaces
Swinging door and gate surfaces within 10 inches (255 mm) of the finish floor or ground measured vertically shall have a smooth surface on the push side extending the full width of the door...
-
505.6 Gripping Surface
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
11B-405.5 Clear width
Handrails may project into the required clear width of the ramp at each side 3½ inches (89 mm) maximum at the handrail height. 3. ...
-
11B-505.6 Gripping surface
Handrail gripping surfaces shall be continuous along their length and shall not be obstructed along their tops or sides....
-
501.1 Scope
Applications may be web-based or client-side software....
-
Common Requirements (R304.5) (Section-by-Section Analysis)
Common Requirements (R304.5) (Section-by-Section Analysis) The clear width of curb ramp runs (excluding flared sides), blended transitions, and turning spaces must be 1.2 meters (4 feet...
-
2.7 Comparing Visual Detection Rates and High Conspicuity Ratings for Detectable Warnings
Note that when detectable warning color was similar to the side walk color, the number of people who would be served by the visual properties of the detectable warning decreased markedly...
-
Accessible Pathway & Corridor: Minimum Clear Width Required for 90-degree Turn
The other side of each leg had moveable walls. The enclosed space was incrementally increased until a user could pass through the turn successfully....
-
1.1.14 Flatness of ramp cross slope
As the ramp gets wider, users may tend to travel toward one side or the other, especially if the ramp is not a curb ramp and has handrails....
-
Hours and Days of Service
For example, if a provider uses its own paratransit vans during high demand periods, it could use a private contractor or user-side subsidy provider during low demand periods....
-
Doors in a Series
Although the final guidelines specify 48 inches as the maximum forward or side reach, the original ADAAG recognized a maximum of 54 inches for side reach....
-
11B-805 Medical care and long-term care facilities
The 18 inch strike-side clearance and 5 feet deep maneuvering clearance are not required at the patient room door in a "non-accessible room," as one not required to provide mobility features...
-
ETA Public Telephone Summary Chart and Survey Instructions
If, in an exterior location, and dial tone first service is available, then a side reach telephone may be installed instead of the required forward reach telephone. [4.1.3(17)(a)3] g....
-
Sales and Service Counters
a maximum height of 36 inches, all accessible sales and service counters must have a clear floor space in front of the accessible surface that permits a customer using a wheelchair to pull...
-
Interacting with People with Visual Disabilities
Never grab or pull people....
-
Width
., not accompanied by a dog or pulling another wheelchair) had widths of 69 cm (27 inches) or less, and would therefore be accommodated by ADAAG. 2....
-
How is slip resistance measured?
evaluated three portable testers: the NBS-Brungraber Tester (also known as the Mark I Slip Tester), the PTI (Pennsylvania Transportation Institute) Drag Sled Tester, and the Horizontal Pull...
-
Lavatories Adjacent to Partitions
space of the lavatory (see attached graphic) In California, we observe the additional requirement for lavatories that are located next to a wall (or partition): 11B-606.6 Adjacent side...
-
FBD Partnership Two Flavors Frozen Beverage Dispenser
draw-time, while reducing compressor run-time Electronic Simplicity offers easy-to-use keypad interface Optimal Use of Counter Space with minimum ventilation of two inches side...
