standards and guidelines....
Search Results "ISO: International Organization for Standardization"
Filters
Commonly Searched Documents
-
2. Amended TTY Requirements
-
2. What does the ADA require for accessibility of pools?
You can see the 2010 ADA Standards at http://www.ada.gov/2010ADAstandards_index.htm....
-
Passenger Loading Zones
Where passenger loading zones are provided, the 1991 Standards, at sections 4.1.2(5) and 4.6.6, require at least one passenger loading zone to be accessible....
-
205 and 309 Operable Parts
205 and 309 Operable Parts Section 4.1.3, and more specifically sections 4.1.3(13), 4.27.3, and 4.27.4 of the 1991 Standards, require operable parts on accessible elements, along accessible...
-
Use of Mandatory Language in Proposed Guidelines
proposed guidelines use the mandatory language “shall” and “requirement” because the guidelines are intended to be adopted, with or without additions and modifications, as accessibility standards...
-
ENDNOTES
iv The Access Board, ADAAG Standards, www.accessboard.gov/adaag v Handinet, www.handinet.org/adaag.htm#4.3 (Accessible Route) The Access Board, ADAAG Standards....
-
5. Exception from the Requirements of M302 for Weight Scales with Integral Seats
Four commenters responded: three concurred (an accessibility consultant, disability rights organization, and a state agency concerned with accessibility); and one commenter (a manufacturer...
-
11B-201.1 Scope
[ADA Title III] §36.406(b) Standards for New Construction and Alterations; Scope of Coverage....
-
a. The employer's judgment
the quality or quantity of work that must be performed by a person holding a job, or be required to set lower standards for the job....
-
M101.1 Purpose (Section-by-Section Analysis)
The MDE NPRM proposed that the purpose of the MDE Standards was to establish technical criteria for diagnostic equipment that is accessible to and usable by patients with disabilities and...
-
Restrooms Main Lobby
See Standards § 4.13.6. l....
-
7. APPLICABILITY
These new DoD Standards are effective immediately....
-
11B-201.1 Scope
[ADA Title III] §36.406(b) Standards for New Construction and Alterations; Scope of Coverage....
-
Viewing Areas
Even though it's not required, renovations almost always provide you with the perfect opportunity to bring the paths up to outdoor recreation access route standards so that everyone can...
-
INTRODUCTION
These changes include revised accessibility standards, called the 2010 Standards for Accessible Design (2010 Standards), which establish minimum criteria for accessibility in design and...
-
11B-202.3.1 Prohibited reduction in access
(c) If the 2010 Standards reduce the technical requirements or the number of required accessible elements below the number required by the 1991 Standards, the technical requirements or the...
-
5.2.2.1 Transfer Surface Width Recommendations for M302
recommends 21 inches for the minimum width of the transfer surface of examination chairs and other equipment primarily used by patients in a seated position as described in its proposed standard...
-
B.3.iv - Who makes the determination that a product meets equivalent facilitation?
The vendor may assert that its product meets or exceeds the level of accessibility required by a particular standard through equivalent facilitation....
-
24.1 Q. What types of grab bars should the reinforcement be designed to accommodate and what types may be used if the builder elects to install grab bars in some units at the time of construction?
In determining what is an appropriate grab bar, builders are encouraged to look to the 1986 ANSI A117.1 standard, the standard cited in the Fair Housing Act....
-
§ 36.304(d)(2)(iii)
., elements for which there are neither technical nor scoping specifications in the 1991 Standards), and therefore those elements must be modified to the extent readily achievable to comply...
-
Alterations and Additions
This guide provides an introduction to the scoping requirements that form the basis for the Department of Justice’s 2010 ADA Standards and the Department of Transportation's ADA Standards...
-
11B-202.3.1 Prohibited reduction in access
(c) If the 2010 Standards reduce the technical requirements or the number of required accessible elements below the number required by the 1991 Standards, the technical requirements or the...
-
Sales and Service Counters
An accessible checkout aisle should provide a minimum of a 36-inch-wide access aisle and it should be identified by a sign with the international symbol of accessibility mounted over the...
-
1022.9 Stairway identification signs
To see the entire Section, consult California Code of Regulations, Title 24, Part 2 - 2013 California Building Code (2013 CBC), available for purchase from International Code Council (http...