[See subsections ...]
Search Results "Operation (Control)"
Commonly Searched Documents
- 
    
  
  M307 Operable Parts
  
- 
    
  
  § 1194.31(f)
  (f) At least one mode of operation and information retrieval that does not require fine motor control or simultaneous actions and that is operable with limited reach and strength shall be... 
- 
    
  
  11B-707.3 Operable parts
  Operable parts shall comply with Section 11B-309.... 
- 
    
  
  11B-813.2.1.3 Height and operation
  Operable parts shall comply with Section 11B-309.... 
- 
    
  
  Push Plates, Buttons, and Bars
  Push-activated controls not requiring more than 5 lbf are acceptable. Buttons that are raised or flush are easier to use than those that are recessed.... 
- 
    
  
  407.12.3.2.1 Height
  The height of the operable part shall conform to Table 407.12.3.2.1.... 
- 
    
  
  407.12.3.2.1 Height (Section-by-Section Analysis)
  407.12.3.2.1 Height (Section-by-Section Analysis) This section, presented in tabular form (Table 407.12.3.2.1), proposes alternative maximum heights for operable parts with obstructed... 
- 
    
  
  407.1 General
  Where provided, operable parts used in the normal operation of ICT shall conform to 407.... 
- 
    
  
  404.2.7 Door and Gate Hardware
  Handles, pulls, latches, locks, and other operable parts on doors and gates shall comply with 309.4.... 
- 
    
  
  This is great!
  I like this discussion 
- 
    
  
  M14
  Is the operating control (switch, lever, button, or pull) for each type of dispenser or built-in equipment no higher than 54 inches above the floor (if there is clear floor space for a parallel... 
- 
    
  
  M307.2 Tactilely Discernible
  Operable parts shall be tactilely discernible without activation.... 
- 
    
  
  M307.2 Tactilely Discernible
  Operable parts shall be tactilely discernible without activation.... 
- 
    
  
  407.1 General
  Where provided, operable parts of ICT shall conform to 407.... 
- 
    
  
  11B-707.9.1, 11B-707.9.2 Point-of-sale devices
  Removes and relocates to 11B-707.3 requirements specific to operable parts.... 
- 
    
  
  §382.57(c)(3)(ii) Timing
  (ii) Timing. Where a timed response is required, the user must be alerted visually and by touch or sound and must be given the opportunity to indicate that more time is required; 
- 
    
  
  § 382.57(c)(3)(ii) Timing
  (ii) Timing. Where a timed response is required, the user must be alerted visually and by touch or sound and must be given the opportunity to indicate that more time is required; 
- 
    
  
  309.2 Clear Floor Space
  A clear floor or ground space complying with 305 shall be provided. 
- 309.4 Accessible Low Drinking Fountain Operation
- 
    
  
  T304.3 Location
  Operable parts provided at a wheelchair space shall be located adjacent to the wheelchair space 24 inches (610 mm) minimum and 36 inches (915 mm) maximum from the rear of the wheelchair... 
- 
    
  
  11B-411.2.1.4.2 Security or access controls
  Security or access control system card readers associated with elevator operation shall be in close proximity to each hall call console in a consistent manner throughout the facility.... 
- 
    
  
  T505.3 Location of Operable Parts
  Operable parts shall be located so that they are reachable by passengers using wheelchair when parked in a clear space 30 inches (760 mm) wide minimum and 48 inches (1220 mm) long minimum... 
- 
    
  
  § 382.57(c)(3) Operable parts
  (3) Operable parts. Operable parts must comply with section 309 of the 2010 ADA Standards, and the following requirements:... 
