Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack....
Search Results "Industry Standard"
Commonly Searched Documents
-
706.2 Receiver Jacks
-
11B-706.2 Receiver jacks
Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack....
-
706.2 Receiver Jacks
Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack. [ECTCR UFAS 4.33.7]...
-
706.2 Receiver Jacks
Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack....
-
11B-706.2 Receiver jacks
Receivers required for use with an assistive listening system shall include a 1/8 inch (3.2 mm) standard mono jack....
-
Can you upgrade/expand an existing location without adhering to ADA standards?
RESPONSE: No. To the extent that EVCS are a public accommodation or commercial facility they are covered by the federal law of the Americans with Disabilities Act. The new...
-
Note Regarding Comparative Table
document and in the second column, the UFAS and/or HUD Section 504 regulation provisions that would need to be complied with because the entity could not use that section of the ADA 2010 Standards...
-
I. Overview
When more than one law and accessibility standard applies, it is currently necessary for the recipient to determine on a section-by-section basis which standard affords greater accessibility...
-
Automatic and Power-Assisted Doors and Gates: ADA Standard Section 404.3
Section 404.3 covers the current ADA Standards for automatic and power-assisted doors and gates.
-
E102.6 ISO (Section-by-Section Analysis)
This is an international standard for accessible portable document format (PDF) files....
-
Architectural Barriers Act
The General Services Administration is required to issue accessibility standards for facilities covered by the Architectural Barriers Act.9 See 42 U.S.C. 4156....
-
Appendix to §36.304(d) Compliance Dates and Applicable Standards for Barrier Removal and Safe Harbor
the 1991 Standards must be modified to the extent readily achievable....
-
29 CFR Part 1607 Uniform Guidelines on Employee Selection Procedures
[See subsections ...]
-
Chapter M3 Technical Criteria
Chapter M3 provides technical criteria for accessible diagnostic equipment based on the patient positions that the equipment is designed to support, including equipment used by...
-
[2010 ADAS] 105.2.1 ANSI/BHMA
ANSI/BHMA A156.10-1999 American National Standard for Power Operated Pedestrian Doors (see 404.3)....
-
F247.1 General
The Federal Trail Data Standards classify trails by their designed use and managed use.8 A trail has only one designed use that determines the design, construction, and maintenance parameters...
- ANSI
-
F105.2.1 ANSI/BHMA
Copies of the referenced standards may be obtained from the Builders Hardware Manufacturers Association, 355 Lexington Avenue, 17th floor, New York, NY 10017 (http://www.buildershardware.com...
-
105.2.1 ANSI/BHMA
ANSI/BHMA A156.10-1999 American National Standard for Power Operated Pedestrian Doors (see 404.3)....
-
105.2.1 ANSI/BHMA
ANSI/BHMA A156.10-1999 American National Standard for Power Operated Pedestrian Doors (see 404.3)....
-
[2010 ADAS] 105.2.1 ANSI/BHMA
Copies of the referenced standards may be obtained from the Builders Hardware Manufacturers Association, 355 Lexington Avenue, 17th floor, New York, NY 10017 (http://www.buildershardware.com...
- Figure 707.6.2 Numberic Key Layout – Drawing from the U.S. Access Board
-
Sec. 469.152. Waiver or Modification Prohibited.
The commission may not waive or modify a standard or specification if:...
-
4.10.1 GENERAL
Accessible elevators shall be on an accessible route and shall comply with 4.10 and with the American National Standard Safety Code for Elevators, Dumbwaiters, Escalators, and Moving Walks...