provide a clearance 39 inches (990 mm) wide minimum, 6 inches (150 mm) high minimum measured from the floor, and 36 inches (915 mm) deep minimum measured from the edge of the examination surface...
Search Results "Surface Smoothness"
Filters
Commonly Searched Documents
-
M301.4.1 Clearance in Base
-
102 Dimensions for Adults and Children
are also provided based on children’s dimensions and anthropometrics for drinking fountains, water closets and other elements located in toilet compartments, lavatories and sinks, dining surfaces...
-
703.4.1 Height Above Finish Floor or Ground
Tactile characters on signs shall be located 48 inches (1220 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest tactile character and 60 inches...
-
703.4.1 Height Above Finish Floor or Ground
Tactile characters on signs shall be located 48 inches (1220 mm) minimum above the finish floor or ground surface, measured from the baseline of the lowest tactile character and 60 inches...
-
Ramps [4.8]
The curvature and slope typically result in an uneven surface that makes wheelchair maneuvering difficult because not all wheels rest on the surface....
-
Openings in Beach Access Routes
Openings are gaps in the surface of a beach access route. Gaps include spaces between the planks on a boardwalk and drainage holes in temporary or permanent surfaces....
-
Questionnaire
A full version of the questionnaire given to the subjects after traveling over each surface can be found in Appendix C. The questionnaire was developed by the study investigators....
-
M302.4.1 Clearance in Base
provide a clearance 44 inches (1120 mm) wide minimum, 6 inches (150 mm) high minimum measured from the floor, and 36 inches (915 mm) deep minimum measured from the edge of the examination surface...
-
M301.4.1 Clearance in Base
provide a clearance 44 inches (1120 mm) wide minimum, 6 inches (150 mm) high minimum measured from the floor, and 36 inches (915 mm) deep minimum measured from the edge of the examination surface...
-
11B-801.1 Scope
For example, Section 11B-806 addresses guest rooms in transient lodging facilities while Section 11B-902 contains the technical specifications for dining surfaces....
-
IPS Corporation Truebro® Lav Guard® 2 Undersink Piping Covers
Its smooth surface makes it exceptionally easy to clean and maintain. Strict code compliance minimizes risk....
-
Bobrick Koala Kare Horizontal, Wall Mounted With Stainless Steel Veneer Baby Changing Station KB200-SS
The steel-on-steel hinge has greater resistance to wear and improved durability and the gas spring mechanism ensures smooth open and close of the unit....
-
¾ Inch Minus and ¼ Inch Minus Limestone
The surface stayed soft under foot, enough to see footprints compacted and not return to the surface, but did not show any signs of erosion....
-
Soiltac Liquid Topical
The first noticeable signs of change for this surface came after the first heavy rainfall at the March 2008 testing....
-
5.7.1 Lift Compatibility Clearance in Base for M301
effective, they must deploy at diagnostic equipment such that the boom of the lifts can maneuver far enough over the equipment to safely lower and raise the patient onto and off examination surfaces...
-
Walk
An exterior prepared surface for pedestrian use, including pedestrian areas such as plazas and courts....
-
705.1 General
Detectable warnings shall consist of a surface of truncated domes and shall comply with 705....
-
Ramp
Ramp - A walking surface that has a running slope of greater than 1:20....
-
Grade Break
The line where two surface planes with different grades meet....
-
Ramp
A walking surface that has a running slope steeper than 1:20....
-
Transition Plate
A sloping pedestrian walking surface located at the end(s) of a gangway....
-
6b.
Is the change in level from the floor to the lift surface ramped or beveled? Yes _____ No _____...
-
106.5.76 Walk
An exterior prepared surface for pedestrian use, including pedestrian areas such as plazas and courts....
-
4.9.6 Outdoor Conditions
Outdoor stairs and their approaches shall be designed so that water will not accumulate on walking surfaces....
