spaces be perpendicular instead of parallel, but perpendicular parking spaces are preferred at facilities located on sites because most allow users to park facing in or out depending on the side...
Search Results "Side Grab Bar"
Commonly Searched Documents
-
Can accessible spaces be parallel instead of perpendicular?
-
11B-406.6 Islands
Raised islands in crossings shall be cut through level with the street or have curb ramps at both sides....
-
11B-608.5.1 Reserved
In transfer type shower compartments, the controls, faucets, and shower spray unit shall be installed on the side wall opposite the seat 38 inches (965 mm) minimum and 48 inches (1220 mm...
-
11B-705.1.2.2.2 Parallel curb ramps
Detectable warnings shall extend the full width of the turning space at the demarcation between the street and the sidewalk less 2 inches (sic) (51 mm) maximum on each side....
-
Elevator Car Controls
Specifically, the ANSI standard specifies a maximum reach height of 48 inches for forward or side reaches....
-
1. Typical Issues for Individuals Who Use Wheelchairs, Scooters, or other Mobility Devices
Ramps with a vertical rise of more than 6 inches must have handrails on both sides....
-
A4.4.1 GENERAL
The two principal cane techniques are the touch technique, where the cane arcs from side to side and touches points outside both shoulders; and the diagonal technique, where the cane is...
-
A4.4.1 General
The two principal cane techniques are the touch technique, where the cane arcs from side to side and touches points outside both shoulders; and the diagonal technique, where the cane is...
-
4.1.2(16)
Unless otherwise specified, accessible telephones may be either forward or side reach telephones. ** A bank consists of two or more adjacent public telephones, often installed as a unit...
-
1010.1.7 Thresholds
In occupancy Group R-2 or R-3, threshold heights for sliding and side-hinged exterior doors shall be permitted to be up to 7¾ inches (197 mm) in height if all of the following apply:...
- Viking Tactile Blue Braille and Raised Letter Sign
- DORMA TS93 Series Door Closer
- Mockett CH51 Torii Coat Hook Rack
- Hager Companies Door Protection Plate 194S
- Hager Companies Door Protection Plate 193S
- Magnuson Group SOTARE Waste Receptacles
- PlayLSI Braille and Clock Panel Play Component
- Magnuson Group UMEA Waste Receptacles
-
11B-104.1.1 Construction and manufacturing tolerances
Where the requirement states a specified range, such as in 609.4 where grab bars must be installed between 33 inches and 36 inches above the floor, the range provides an adequate tolerance...
-
III-4.4500 Priorities for barrier removal
. , lowering towel dispensers or installing grab bars) in each restroom?...
-
11B-104.1.1 Construction and manufacturing tolerances
Where the requirement states a specified range, such as in 609.4 where grab bars must be installed between 33 inches and 36 inches above the floor, the range provides an adequate tolerance...
- World Disability Union (WDU)
-
11B-405.5 Clear width
Handrails may project into the required clear width of the ramp at each side 3½ inches (89 mm) maximum at the handrail height....
-
Counter Surface Height
The Board has added clarification that the specified height for edge protection at check-out aisle counters applies to the aisle side of the counter (904.3.2)....